Toro manual Power-Up Diagnostics, Home Key, TDC-100/200 System Booting

Power-Up Diagnostics

Upon power-up, the controller will display:

TDC–100/200 System

Booting

The TDC-100/200 will initiate a diagnostic test automatically during power-up. This function will take approximately ten seconds and it can not be bypassed. If a problem is detected during the diagnostic test, it will be indicated on the display.

When completed, information will be displayed momentarily on the screen for five seconds. This status information can not be edited. The information is as follows:

Line 1: TDC-100/200 Firmware Version and Revision Date

Line 2: Detect: [xx stations, yy sensors] (xx = number of stations detected, yy = number of sensors detected)

Line 3: Last Power Downtime Date and Time

Example:

Rev: D1.21, 04/25/06

Detect:200sta, 00sen

PD 05/24/06 10:51:20

The default Home display will follow after the diagnostic display has timed-out.

Home display example:

Mon 08/07/06 10:50am

Sec: 45

Day Change: 12:00am

Home Key

Pressing the Home Key will revert to the default display. When editing irrigation programs, Station or System settings, pressing the Home Key will save any setting modifications and return the user to the Home display.

Home display example:

Mon 08/07/06 10:50am Sec: 45

Day Change: 12:00am

Mon 08/07/06 11:15am

Sec: 50

Rain

Day Change: 12:00am

Rain detected indicator for rain sensor equipped Decoder systems

The Day Change line will display the next program start time (Next Start: HH:MM) if the current day is an active watering day. If the controller is running a program, the Day Change line will display Running XX programs to indicate the number of active programs.

The following example display has two programs running with two stations manually activated, the display will read:

Wed 08/09/06 06:50am Sec: 32

Running 02 Programs

P01 Sta01 %00:05:00

P01 Sta02 00:05:00

P01 Sta03D 00:05:00

P02 Sta10P 00:10:00

Man Sta18S 00:05:00 Man Sta19S 00:10:00

(The “%” symbol before the runtime indicates that station 1 is percent adjusted.) (P01 indicates Program 01 is currently active)

(The “D” symbol after the station number indicates that station 3 is disabled.) (The “P” symbol after the station number indicates that program 02 is paused.)

(“Man” indicates Manual Watering is currently active)

(The “S” symbol after the station number indicates that program 02 is stacked.)

Note: Program stacking occurs when the controller is running a program where the maximum simultaneous station limit is surpassed. Additional scheduled programs will be stacked (delayed) until an available station can be activated.

7