![](/images/new-backgrounds/1265095/26509521x1.webp)
FIELD REPLACEABLE UNIT DOCUMENTATION
TM
Satellite
1800 Series
13.3” DISPLAY MASK REMOVAL
Latch
Display mask
LCD
Mask seals
1.Remove two mask seals at the bottom corners of the display assembly to expose two screws securing the display mask.
2.Remove two M2.5x6 black screws securing the display mask.
3.There are 23 latches securing the display mask. Carefully insert your fingers between the display mask and the LCD module and pry open the latches starting from the seven bottom latches, to the five latches on the right and left sides, ending with the six top latches.
FL INVERTER AND 13.3” LCD REMOVAL
LCD module
M2x3 | M2x5 | |
silver | ||
silver | ||
screws | ||
screws | ||
|
|
| FL cable |
LCD/FL cable | M2x5 brass | Glass tape |
| screw | FL inverter board |
1.Peel off the glass tape securing the FL cable.
2.Remove one M2x5 brass screw securing FL inverter board.
3.Carefully lift up the FL inverter board and disconnect the LCD/FL cable from CN1 and the FL cable
from CN2.
4.Remove four mask seals to expose four screws securing the left and right LCD brackets.
5Remove four M2X5 silver screws securing both brackets.
6.Carefully rotate out the top of the LCD module enough to access the display cable.
7.Peel off the tape securing the LCD/FL cable and disconnect the cable.
8.Remove four M2x3 silver screws securing the left and right LCD brackets.
TOSHIBA
Tough Enough for Today’s World