UsingRemote the olContr
Using the remote control
Learning about the Remote Control
RECALL displays screen information.
CHANNEL NUMBERS
+100 selects channels over 100.
POWER turns the TV on and off.
MUTE mutes the sound.
VIDEO1 selects video 1 mode.
VIDEO2 selects video 2 mode.
MENU allows access to programming menus.
ENTER sets programming menu information
SLEEP sets the TV to go off at a set time.
CH y z cycles through programmed channels. Also used to highlight selections on the
VOL x • adjusts the volume level. Also used to increase or reduce the value of a menu option.
FAV y z cycles through favorite channels.
MTS switches MTS (stereo or SAP) sound.
WOW switches sound effect on and off.
Installing the remote control batteries
To install the batteries:
1.Slide the battery cover off the back of the remote control.
2.Install two ÒAAAÓ size alkaline batteries. Match the + and Ð signs on the batteries to the signs on the battery compartment.
1 | 2 |
3.Slide the battery cover back on to the remote control until the lock snaps.
¥You can use your remote control within a distance of 5m and an angle of 30 degrees from the left and right sides of the remote sensor of your TV.
Caution:
•Dispose of batteries in a designated disposal area. Do not throw batteries into a fire.
•Do not mix battery types or combine used batteries with new ones.
•Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
Note:
•If you do not intend to use the remote control for a long time, remove the batteries.
•If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.
12
