18
Using the TV’s features

Selecting the picture mode

You can select the picture quality instantly among
three preset modes and one user-set mode.
• Press N to select the desired picture quality.
Dynamic
Mode Picture quality
q Dynamic bright and dynamic picture
q Standard standard picture
q Mild soft picture
q Memory the picture quality you set
Note:
In the PC input mode (- page 23), this mode is
not available.

Adjusting the basic picture quality

1 Press M, then press I or i to display the
PICTURE menu.
PICTURE
MENU
Back Watch TV
EXIT
OK
Picture settings
Off
Base color adjustment
3D Color management
Active Backlight Control
On
Cinema mode On
2 Press u or U to select the Picture settings
menu, then press Q.
Tint
Color
Back light
MENU
Back Watch TV
EXIT
100
50
0
0
Sharpness
Contrast 100
Picture settings 1/2
Brightness 50
3 Press u or U to select an item you want to
adjust, then press I or i to adjust the settings
as required.
Contrast 100
Selection IPressing i
Back light darker brighter
Contrast lower higher
Brightness darker brighter
Color paler deeper
Tint reddish greenish
Sharpness softer sharper
Notes:
• The Tint may only be adjusted on NTSC signal.
• In the PC input mode (- page 23), Color, Tint
and Sharpness modes are not available.

Activating the black stretch

This function increases the strength of dark
areas of the picture which improves definition.
1 Press M, then press I or i to display the
PICTURE menu.
PICTURE
MENU
Back Watch TV
EXIT
OK
Picture settings
Off
Base color adjustment
3D Color management
Active Backlight Control
On
Cinema mode On
2 Press u or U to select the Picture settings
menu, then press Q.
3 Press u or U to select Black stretch on the
2nd page.
Color Temperature
Black stretch
MENU
Back Watch TV
EXIT
On
Cool
MPEG NR Low
Picture settings 2/2
DNR Auto
4 Press I or i to select On or Off.
Black stretch On
Note:
In the PC input mode (- page 23), this mode is
not available.

Activating the MPEG NR (Noise Reduction)

If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression
and conversion, the noise may be reduced when
using this function.