Use this feature to verify the codes for your other electronic devices. The number of blinks after pressing the 1, 2, 3, and 4 buttons is the
For example, to verify the device code of the VCR mode:
1.Repeatedly press MODE to select VCR mode.
2.While holding down RECALL, press
3.Press 1 ➝ 2 blinks.
4.Press 2 ➝ 3 blinks.
5.Press 3 ➝ 4 blinks.
6.Press 4 ➝ 5 blinks.
This verifies that the device code of the VCR mode is “2345.”
Using the Volume Lock feature (993)For the TV, CABLE/SAT, VCR, and DVD modes, the volume controls (VOL yz and MUTE) can be programmed (locked) to the selected device mode. This feature does not apply to the AUDIO1/2 modes.
For example, to lock the volume controls to always jump to the CABLE/SAT mode:
1.Repeatedly press MODE to select the CABLE/SAT mode.
2.While holding down RECALL, press
3.Press VOL y. The Mode indicator will blink two times (locked).
The following table describes in more detail the Volume Lock implementation.
Volume | TV | CBL/SAT | VCR | DVD | AUD1 | AUD2 | |
Locked to: | |||||||
|
|
|
|
|
| ||
TV (default) | TV | TV | TV | TV | AUD1 | AUD2 | |
CBL/SAT | CBL/SAT | CBL/SAT | CBL/SAT | CBL/SAT | AUD1 | AUD2 | |
VCR | VCR | VCR | VCR | VCR | AUD1 | AUD2 | |
DVD | DVD | DVD | DVD | DVD | AUD1 | AUD2 | |
AUD1 | AUD1 | AUD1 | AUD1 | AUD1 | AUD1 | AUD1 | |
AUD2 | AUD2 | AUD2 | AUD2 | AUD2 | AUD2 | AUD2 |
To reset the volume controls to the original device code:
1.While holding down RECALL, press
2.Press VOL z. The Mode indicator will blink four times (unlocked).
Operational feature Reset (980)This feature clears all setup features not related to “Device code set up” and resets the Volume Lock to “TV.”
To reset the features:
While holding down RECALL, press
The Mode indicator will blink two times, and then pause and blink two more times.
Number
MODE
VOL y z
RECALL
Introduction |
|
|
|
|
|
Connecting | yourTV |
|
|
|
|
Usingthe | RemoteControl |
|
|
|
|
Settingup | yourTV |
|
|
|
|
UsingtheTV’s | Features |
|
|
|
|
Appendix |
|
|
|
|
|
Index |
|
|
|
32/36AFX61(E) 15