Chapter 4: Initial Setup and Menu
26
6無 Start Scan
Start Scan
Auto Tuning
Press .
Note: If you want to stop scanning, press
while scanning.
•After scanning is complete, a channel list screen
(such as the one below) will appear. Press or
.
Note: Encrypted channels cannot be registered
though these are displayed in the above list.
If some channels are not found after scanning:
•Check the antenna/cable connections, and scan
again.
•Connect the TV to the antenna or cable box directly
and scan again.
1無 > Settings > SETUP > Quick Setup > .
2無 A confirmation message appears. Press
t or u
to select Yes. Press .
3無 Repeat set up to Step 6.
•If you selected Antenna previously, select
Cable.
•If you selected Cable previously, select
Antenna.
4無 Scan again.
7無 Support Information
The Support Information screen appears. Press .
Note: Refer to this information if there is any
problem and you need to contact Customer
Support. This can be confirmed from the
following operation at any time.
> Settings > SETUP > System Information >
.
Navigating the menu system• To open the main menu, press on the remote
control or TV control panel.
• Press p, q, t, or u on the remote control or TV
control panel to navigate and make selections.
• To select a menu option, press .
• To move to the next menu layer, press or p.
• To return to the previous menu layer, press or q.
• To close a menu instantly, press or
.
• All menus will close automatically if you do not make
a selection within 60 seconds.