Programming the remote control

The remote control is preprogrammed to operate most Toshiba VCRs and cable TV converters. To program the remote control to operate a non-Toshiba device or a Toshiba device that the remote control is not

preprogrammed to operate:

1.Refer to the “VCR code table” or “Cable TV converter code table” on pages 16–17 to find the corresponding code for your VCR or cable TV converter brand.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are reprogramming the remote control to operate your:

•VCR: Set the TV/CABLE/VCR switch on the remote control to VCR.

•Cable converter: Set the TV/CABLE/VCR switch on the remote control to CABLE.

3.While holding down the RECALL button, press the Number buttons (0–9) to enter the three-digit code for your VCR or cable TV converter.

4.Point the remote control at the VCR or converter and press POWER to test the code.

If the VCR or converter responds, you have entered the correct code.

If the VCR or converter does not respond, you may have entered the wrong code. Repeat steps 1–4 using another code.

Note: In addition to POWER, confirm that all necessary keys on the TV remote control operate your device. If some keys are not operational, repeat the device code setup using another code (if other codes are listed for your device). If, after trying all listed codes, the necessary keys do not operate your device, use the device’s original remote control.

5.Reset the TV/CABLE/VCR switch to TV to control the TV.

For future reference, write down the code(s) you used:

VCR code ________________________________

Cable TV converter code ____________________

 

 

 

 

RECALL

 

LIGHT RECALL POWER

 

TV

 

 

 

POWER

 

 

 

 

CABLE

MUTE TV/VIDEO TIMER

 

VCR

 

 

 

 

 

1

2

3

 

Channel yz

 

 

 

CH

4

5

6

 

Channel

7

8

9

 

VOL

Number

 

 

CH RTN

 

100

0

ENT

 

Enter

 

 

 

 

 

 

ADV/

 

 

FAVORITE

PIP CH

PIC

 

 

 

 

 

 

 

SIZE

 

FAV

MENU/

FAV

 

ENTER

 

 

 

 

STROBE

 

ADV/

EXIT

 

PIP CH

Note:

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”

If your VCR has this kind of switch and does not respond to any of the codes for your VCR brand, set the switch to the other position (VCR1 or VCR2) and reprogram

the remote control.

Introduction

 

 

 

 

 

Connecting

yourTV

 

 

 

 

Usingthe

RemoteControl

 

 

 

 

Settingup

yourTV

 

 

 

 

UsingtheTV’s

Features

 

 

 

 

Appendix

 

 

 

 

 

Index

 

 

 

15