Chapter 5: Setting up your TV

4 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Program to bring up the Start, and press T again to begin channel programming.

Installation

Terrestrial

 

Input Configuration

 

Channel Program

Start

Channel Add/Delete

 

Signal Meter

 

ANT Antenna

Scanning channels, please wait ...

52%

Number of Channels Found - 73

Scanning Digital Channels

Found Channel - 118

Abort

The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears (as shown above).

5 To cancel channel programming, press Oon the remote

control (or highlight Abort in the on-screen display and

T

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number you want to add, and then press Tto check the box.

To manually add digital subchannels on a physical channel:

Use the Channel Numbers and the Dash (=) on the remote control to enter the channel number (for example, 56–1).

If the channel is found, the number will be added to the list and the box will be checked.

If the channel is not found, a message will appear.

To remove a channel from the channel memory:

Highlight the checked box next to the channel number you want to remove, and then press Tto uncheck the box.

To save your new settings:

Highlight Done and press T.

To revert to your original settings:

Highlight Cancel and press Tbefore saving.

To remove all channels from the channel memory:

Highlight Reset and press T, and then highlight Done and press T.

press ).

When channel programming is finished, press <or ,to view the programmed channels.

Manually adding and deleting channels in the channel memory

After automatically programming channels into the channel memory, you can manually add or delete individual channels.

Channel Add/Delete

2

2-1

2-2

3

4

5

6

7

7-1

8

Analog

Digital

Digital

Analog

Analog

Digital

Analog

Analog Reset

Digital Cancel

Analog Done

To add or delete channels in the channel memory:

1 Press Yand open the Setup menu.

2 Highlight Installation and press T.

3 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Add/Delete, and then press T.

Installation

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

To remove encrypted channels from the channel memory:

If an encrypted channel is accidentally added to the channel list by programming channels, you can remove the unwanted encrypted (non-viewable) channel while you are channel surfing. When you tunes to an encrypted channel, the following message will appear.

Digital Channel Is Encrypted - Press 1 on remote to remove channel

Press “1” button while the message is on the screen to remove the unnecessary channel from the channel list.

45

Page 45
Image 45
Toshiba 42LX177 manual Manually adding and deleting channels in the channel memory