Toshiba 40RV525U, 46RV525U Programming channels automatically, To program channels automatically

Chapter 5: Setting up your TV

Programming channels into the TV’s channel memory

When you press or on the remote control or TV control panel, your TV will stop only on the channels you programmed into the TV’s channel memory.

Follow the steps below to program channels into the TV’s channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory.

Note:

•You must configure the ANT/CABLE input source before

programming channels ( page 30).

•The automatic channel programming process will erases channels that were previously programmed into the TV’s memory.

•To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

•Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly.

To program channels automatically:

1 Configure the antenna input source, if you have not already done so ( page 30).

2 Press and open the Setup menu.

3 Highlight Installation and press .

Setup

Installation

HDMI Control Setup

Sleep Timer

PC Settings

Logo LED Off

4 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Program to bring up the Start, and press again to begin channel programming.

The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears (as shown above).

5 To cancel channel programming, press on the remote control (or highlight Cancel in the on-screen display and press ).

When channel programming is finished, press or to view the programmed channels.

Manually adding and deleting channels in the channel memory

After automatically programming channels into the channel memory, you can manually add or delete individual channels.

To add or delete channels in the channel memory:

1 From the Setup menu, highlight Installation and press . A new set of Installation menu icons will appear.

2 Open the Terrestrial menu, highlightChannel Add/ Delete, and then press .

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number you want to add, and then press to check the box.

(continued)

31