Toshiba 46HM15, 62HM15A owner manual Viewing the CableCARD menu, Setting the Quick Restart Feature

Chapter 6: Setting up your TV

Viewing the CableCARD™ menu

A CableCARD™ enables you to view encrypted digital channels. See page 12 for connection and subscription information.

After the CableCARD™ is inserted, a CableCARD™ option appears in the Applications menu, with informational screens provided by your digital CableCARD™ service (see illustrations below).

CableCard Connected -- Acquiring channel information.

CableCard services will only operate with cable signal connected to Antenna 1.

To view the CableCARD™ menu:

1.Press MENU and open the Applications menu.

2.Highlight CableCARD™ and press •.

3.Press z or y to select one of the side menu items and press ENTER to display the information.

Applications

TV Guide On Screen		IP Service
Audio Player		Conditional Access
Picture Viewer		CableCARD(tm) Status
Digital CC/Audio Selector		Network Setup
CableCARD		CableCARD(tm) Pairing
Navigate	Select	CH RTN Back EXIT Exit

Note: The CableCARD™ menu is for informational purposes only and has no user-adjustable options.

Setting the Quick Restart™ Feature

With the Quick Restart™ feature set to ON, the TV will stay in Low Power Shutdown mode for several minutes after the TV is turned off (see Notes below).

If the TV is turned on from Low Power Shutdown mode, the full picture appears immediately.

To set the Quick Restart™ feature:

1.Press MENU, and then press x or • until the Setup menu appears.

2.Press z or y to highlight Quick Restart, and then press •.

3.Press z or y to select either “On” or “Off” and press ENTER to display the information.

Setup

On/Off Timer			Off
HDMI 1 Audio		Auto	On
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Gray Level		2
Quick Restart		On
Navigate	Select CH RTN Back		EXIT Exit

Note:

If Quick Restart is set to Off and you turn off the TV, it can take

several seconds for the picture to appear when you turn on the TV again. See "IMPORTANT NOTICE ABOUT HOT LAMP RESTART," below.

If Quick Restart is set to On and you turn off the TV, the following will occur for a few minutes:

•The screen (lamp) lights dimly.

•The fans continue to run.

This is a function of the Quick Restart Low Power Shutdown mode and is not a TV malfunction. If you do not prefer this, set the Quick Restart feature to Off.

When the Quick Restart feature is set to Off, if you repeatedly turn the TV on and off in a short period of time, the useful service life of the lamp may be shorter than the average useful service life. See page 103.

IMPORTANT NOTICE ABOUT “HOT LAMP RESTART”

When the TV has been powered on long enough for the lamp unit to get hot, it may take several minutes for the picture to appear on-screen in the following situations:

•When the Quick Restart™ feature is set to OFF and you turn the TV off and then on again within a few minutes.

•If the TV is on when a short-term power failure, power surge, or other similar power failure occurs, such that the TV loses and regains power within a few minutes.

This is a property of DLP TV lamp technology and is NOT a sign of malfunction.

If this occurs, the green LED on the TV front panel will blink (and the red LED will be lit solid) until the TV is finished restarting the lamp and the normal picture appears. If BOTH green and red LEDs are blinking at a one-second rate, you will need to turn the TV off and then on again to restart the lamp.

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 51