Toshiba 46HM15 Setting up your TV, Selecting the menu language, To select the menu language

6 Setting up your TV

For menu navigation instructions, see Chapter 4.

Selecting the menu language

You can choose from three different languages (English, French and Spanish) for the on-screen display of menus and messages. (The TV Guide On Screen® menus are in English, regardless of the language selected in this menu.)

To select the menu language:

1.Press MENU and open the Preferences menu.

2.Highlight Menu Language and press •.

3.Highlight your preferred menu language in the menu sidebar and press ENTER.

Preferences

Favorite Channels		English
Closed Caption Mode	Off	Français
Closed Caption Advanced		Español
Input Labeling
Menu Language	English
Home CH Setup
Navigate	Select CH RTN Back	EXIT Exit

4. Press EXIT to close the Preferences menu.

Configuring the antenna input sources

To configure the ANT 1 and ANT 2 input sources:

1.Press MENU and open the Setup menu.

2.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen, as shown in step 3 below.)

Setup

Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio		Auto
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Navigate	Select CH RTN Back EXIT Exit

3.Open the Terrestrial menu, highlight Input Configuration, and press ENTER.

Note: The Terrestrial menu may not be accessible (items will be “grayed out”) in some instances (for example, if a cable box is connected to the ANT 1 input or if one of the VIDEO modes is the current input during TV Guide On Screen® setup).

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate Select CH RTN Back EXIT Exit

4.Press x or • to select the input source (Cable or Antenna) for the ANT 1 input on the TV.

Note: If a cable box is connected to the ANT 1 input during TV Guide On Screen® setup, the entire Terrestrial menu will not be accessible, including the input source for ANT 1, which will automatically display “Cable Box.”

5.Press z and then x or • to select the input source (Cable or antenna) for the ANT 2 input on the TV, if applicable. If you have not connected anything to ANT 2, skip this step.

Input Configuration

Antenna 1 In		Cable
Antenna 2 In		Antenna
	Cancel	Done

6.To save your new settings, highlight Done and press ENTER. To revert to your original settings, highlight Cancel and press ENTER.

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 41