Toshiba 62HM196 manual Setting the time and date, To set the time and date

HM196_EN.book Page 28 Tuesday, May 30, 2006 2:18 PM

Chapter 4: Setting up your TV

Setting the time and date

Note: If you already set up the TV Guide On Screen™ system, the time and date were set automatically and you can skip this step.

To set the time and date:

1 Press Yand open the Setup menu.

2 Highlight Installation and press T.

3 (A new set of Installation menu icons will appear, as shown below.) Open the Time And Date menu, highlight Start Setup, and press T.

Time And Date

Start Setup

Navigate ENTER Select CH RTN Back EXIT Exit

If you have not set up the TV Guide On Screen™ system, the following screen will appear. To set the time, highlight TV Guide On Screen™ and press T. The TV Guide On Screen™ setup sequence will start, and the time and date will be set automatically.

Time And Date

Your TV Guide On Screen system can provide accurate

time and date information.

It is recommended you set up TV Guide On Screen

first and use it to obtain the time and date.

Manual TV Guide On Screen Cancel

If you have already set up the TV Guide On Screen™ system, or if you have not set up the time, the Time and Date setting screen will appear and you will need to manually set the time and date.

Time And Date
Date (MM/DD/YY)
	0	6	/	3	0	/	0	5
Time (HH:MM)	1	1	:	1	1		AM

In the event that your TV Guide On Screen system has acquired time, the television will use network acquired time rather than manually enterred time.

Cancel Done

Note:

•If you highlight TV Guide On Screen™ (above) to set the time and date through the TV Guide On Screen™ system and a power outage occurs, the time and date will be updated automatically when the power is restored.

•If you highlight Manual (above) to set the time and date manually and a power outage occurs, you will lose the time and date settings when the power is restored.

•If you manually set the time and date and then perform TV Guide On Screen™ setup, the manual time and date settings will be overridden by the TV Guide On Screen™ settings.

Setting the ColorStream® HD audio mode

To set the ColorStream HD audio mode:

1 Press Yand open the Setup menu.

2 Highlight ColorStream HD1 Audio (or ColorStream HD 2 Audio) and press c.

3 Press B or b to select Yes or No and press Tto display the information.

Setup

Installation		No
Sleep Timer		Yes
On/Off Timer
ColorStream HD1 Audio No
HDMI 1 Audio	Auto
ColorStream HD2 Audio	No
HDMI 2 Audio	Auto
Navigate ENTER Select	CH RTN Back EXIT Exit

Note: The analog audio terminals for the ColorStream HD and HDMI inputs are used in common. When the ColorStream HD 1 (or 2) audio mode is set to Yes, the HDMI 1 (or 2) audio mode is set to Digital and will be grayed out. When the ColorStream HD 1 (or 2) audio mode is set to No, the HDMI 1 (or 2) Audio changes to Auto.

28

HM196 (E/F) Web 213:276