Toshiba A100 user manual AAnswer command, BnCommunication standard setting, DnDial

APPENDIX C

User’s Manual

AAnswer command

This command instructs the modem to go off-hook and answer an incoming call.

BnCommunication standard setting

This command determines the communication standard CCITT or Bell.

B0 Selects CCITT V.22 mode when the modem is at 1200 bps.

B1 Selects Bell 212A when the modem is at 1200 bps (default). B15 Selects V.21 when the modem is at 300 bps.

B16 Selects Bell 103J when the modem is at 300 bps (default). Result Codes:

OK n=0,1,15,16 ERROR Otherwise

DnDial

This command instructs the modem to dial a telephone number. Enter n (the telephone number and any modifiers) after the ATD command.

Any digit or symbol (0-9, *, #, A, B, C, D) may be dialed as touch-tone digits. Characters such as spaces, hyphens, and parentheses do not count. They are ignored by the modem, but you may want to include them to make the number and modifiers easier to read.

The following may be used as phone number modifiers:

PPulse dialing.

TTouch-tone dialing (default).

,Pause during dialing. Pause for time specified in Register S8 before processing the next character in the dial string.

WWait for dial tone. Modem waits for a second dial tone before processing the dial string.

@Wait for quiet answer. Wait for five seconds of silence after dial- ing the number. If silence is not detected, the modem sends a NO ANSWER result code back to the caller.

!Hook flash. Causes the modem to go on-hook for 0.5 seconds and then return to off-hook.

C-2