68 Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 3.1
You may also change the enable/disable setting as follows:
1Click Start, Control Panel.
The Control Panel window appears.
2Click Printers and Other Hardware.
3Click Mouse.
The Mouse Properties window appears.
4Click the TouchPAD ON/OFF tab.
The TouchPAD ON/OFF tab view window appears.
5Select Disable or Enable, whichever is appropriate.
6Click Apply.
7Click OK.
The Mouse Properties window closes.
8Close the Printers and Other Hardware window.
9Close the Control Panel window.
Installing additional memory (optional)
Before you install or remove a memory module, turn off the
computer using the Start menu. If you install or remove a
memory module while the computer is in Standby or
Hibernation mode, data will be lost.
A memory module must be installed in slot A. Do not try to
operate the computer with a memory module in slot B only.
If you install a memory module that is incompatible with the
computer, a beep will sound when you turn on the computer. If
the module is installed in slot A, there will be a long beep
followed by a short beep. If the module is in slot B, there will
be a long beep followed by two short beeps. In this case, turn
off the computer and remove the incompatible module.