MAINTENANCE
Lint collector
Clean the lint collector after every use.
How to remove
Insert fingers deeply into the recess. By strongly holding down the collector, pull it toward you.
How to replace
Check the top and bottom of the collector. Then mount the bottom. Hold down the recess, press the collector against the collector mounting base until the shaft fits into position.
•In the event that the net is damaged, consult your nearest dealer.
Softener case
Remove and clean after every ten usages.
Removal
1Hold down the each.
2And pull toward you.
Caution
•Water in the case may freeze in cold weather.
If this occurs, remove the case, immerse in warm water (less than 40°C) for 10 minutes, and replace after dried well.
Installation | Catch |
1Fit in the bottom.
2Then press in the top until the catch catches.
Softener case
Detergent case
Remove the case to clean it. In addition, wipe away any dirt from the water supply port.
Removing the case | Remounting procedure |
Removal procedure;
Pull the detergent case toward you, then lift it for removal.
Lift the case obliquely in the same way as you remove it, and insert it deeply along the guides.
Guides
12
12 | 12/12/06, 9:55 |
