INSTALLATION
If the filling water becomes not good
The water inlet may be blocked by foreign objects. Remove the water supply hose and clean the filter with a brush.
•If you remove the water supply care- lessly, water may splash. Therefore, use the following procedure.
Filter
Water intake valve
Removing the water supply hose
1Turn the water faucet off.
2Turn the power switch ON and press the START/HOLD pad.
3After indicating the water level, loosen the hose nut of the machine top and remove it.
In case of water may freeze
Drain all water from the basket, drainage hose and water supply hose after using the machine.
If the water is frozen | under 40°C |
1Remove the water supply hose and pour in warm water (under 40°C).
2Fill warm water (under 40°C) into the basket until the pulsator is completely covered. Leave it for 30 minutes.Then check to see whether the pulsator can be turned by hand.
Installing the bottom cover
Put the bottom cover into the bottom of the washing machine, and fix the bottom cover with screws.
1Lay down the washing machine on a flat object such as a corrugated board so that the front side is down.
2Align the bottom cover with the taps of the hooks of the bottom cover left & right. (4 taps)
FRONT
FRONT
3 Fasten the screws on 6 positions.
BOTTOM COVER (LEFT)
BOTTOM COVER (RIGHT)
SUPPORT PLATE
*The service technician will mount the bottom cover when installing the unit.
17
