APPENDIX 1 SPECIFICATIONS | ENGLISH VERSION |
| A1.3 Media |
|
|
1.3.1 | Media Type (Cont.) |
|
|
|
| |
|
|
|
|
| Unit: mm (inch) | |
|
|
|
|
|
| |
? | Issue mode | Batch mode |
| Strip mode | Cut mode | |
Item |
|
|
|
|
| |
@Width including backing paper | 25.4 to 112 (1.0 to 4.4) |
| ||||
AMedia width |
|
| Min. 17 (0.7) |
| ||
BMedia pitch | 10 to 609 (0.39 to 24.0) |
| 15 to 609 (0.59 to 24.0) | |||
CMedia length | Min. 10 (0.39) |
| Min. 15 (0.59) | |||
DGap length (or black mark length) | Min. 2 |
| Min. 6 | |||
Black mark width |
|
| Min. 8 |
| ||
Thickness |
|
| 0.06 to 0.19 |
| ||
Max. outer roll diameter |
|
| Ø 127 (5) |
| ||
Ø 214 (8.4): When the optional External Media Roll Hanger is used. | ||||||
|
| |||||
Roll direction |
| Either is acceptable. |
| |||
Outside roll media; Linerless paper (option) | ||||||
|
| |||||
Inner core diameter | 25.4, 38.1, or 76.2 (1, 1.5, or 3) (See NOTE 2.) | |||||
NOTES:
1.To ensure print quality and print head life use only TOSHIBA TEC approved media.
2.When using a media roll of
A1.3.2 Detection Area of the Transmissive Sensor
The Transmissive Sensor is positioned 6 mm from the centre.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Centre of media
|
|
|
| Area to be detected. | ||
Sensor position |
|
|
| |||
|
|
|
|
|
| Label |
Min. 2 mm |
|
|
|
|
| Gap |
|
|
|
|
| ||
|
|
|
|
| ||
(Min. 6 mm: |
|
|
|
| Label | |
|
|
|
| |||
|
|
|
|
|
| |
cut mode)
Min. 8 mm
Sensor position
Print side
Media feed direction
6 mm
A1.3.3 Detection Area of the Reflective Sensor
The Reflective Sensor is movable within the full range of the media width.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.
Sensor should be positioned at the centre of the black mark.
Min. 2 mm (Min. 6 mm: Cut mode)
Min. 8 mm
Detecting the black marks on the back.
Media feed direction
Sensor is movable within the full range.
EA1- 3
