Toshiba BDX3000KU owner manual Network List, WiFi-me

Customizing the Function Settings

The symbols that might appear next to each listed wireless network in the network list are as follows:

Category	Icon	Definition
Connected		When the BD player is turned on, it
		will connect to the wireless network
		displaying this symbol. Typically,
		this is the last wireless network
		connected before powering down.
	*	Indicates that the BD Player is cur-
		rently connected to this network.
Saved		The wireless network properties
		have been saved in the BD player’s
		memory.
Wireless		The wireless network data is not
Security		encrypted.
		The wireless network data is
		encrypted; a ‘security key’ must be
		entered so that the BD player can
		share data over the network.
		The wireless network data is en-
		crypted; the encryption scheme is
		not supported by the BD player.
Wireless	a	The wireless network supports
Protocol		802.11a

bThe wireless network supports 802.11b

gThe wireless network supports 802.11g

nThe wireless network supports 802.11n

The wireless router supports the WPS standard.

Signal	Strong Signal
Strength
	Good Signal

Medium Signal

Weak Signal

No Signal

I.Connection to the wireless Network which you select

Wireless

Network List

WiFi Protected Setup (WPS)

Manual

IP Settings

1.In the “Wireless” menu, press / to select Network List, then press OK. A list of existing wireless networks near the BD player will appear (It may take several seconds for this list to be created). For example:

	Network List
WiFi a	WiFi-me*
WiFi b g n	Panda
WiFi a	dlink_media
WiFi b g	NTGR 11g
WiFi b g	Airport_SN

2.Press / to select the desired wireless network, and press OK to confirm.

a. If the BD player is connected to an Unencrypted Wireless Network, a menu similar to the following will

appear:

WiFi-me

Connect WPS Pin Cancel

Name and Password are case-sensitive

3.Press / to highlight Connect, and press OK. If the

wireless network is functioning, icon and a message “Connection to XXX...Success” will appear on the TV.

4.Press OK to close the message. The BD disc player is now connected to the network. From now on, when you turn on the player, it will automatically connect to the network; there is no need to repeat these steps again.

Note: If you do not see this message, the BD player was not able to connect to the network.

b. If the BD player is connected to an Encrypted Wireless Network, a menu similar to the following will

appear:

WiFi-me

Password

Connect WPS Pin Cancel

Press ENTER to open keyboard

Password is case-sensitive

3.Press ENTER to activate the on-screen keyboard. Carefully enter the network password by using the / / / to highlight the desired letter on the keyboard, and then pressing OK. (If you make a mistake, use the

backspace key to erase the mistake.)

FUNCTION SETUP

37