Appearance, Dimensions, Front View | Toshiba B-SX4T Series guide

1. PRODUCT OVERVIEW

ENGLISH VERSION EO1-33034

1.5 Appearance

1.5 Appearance

The names of the parts or units introduced in this section are used in the following chapters.

1.5.1 Dimensions

291 (11.5)

460 (18.1)

308

(12.1)

Dimensions in mm (inches)

1.5.2 Front View

LCD Message Display

Top Cover

Operation Panel

Supply Window

Media Outlet

1.5.3 Rear View

Parallel Interface

Connector (Centronics)

Serial Interface

Connector (RS-232C)

AC Power Inlet

PCMCIA Card Slot (Option), USB Connector (Option), or LAN Connector (Option)

USB Connector

(Option) or LAN

Connector (Option)

Expansion I/O Interface Connector (Option)

{Power Switch

:OFF

: ON

E1- 3

Image 9

Toshiba B-SX4T Series, BSX4TGS20QMR owner manual Appearance, Dimensions, Front View, Rear View

Contents

SX4T Series Vorsicht CE Compliance for EU only Wkhsoxj Request Regarding Maintenance Precautions Table of Contents EA2-1 EA1-1EA3-1 EA4-1 Introduction Features Product OverviewUnpacking Accessories Appearance DimensionsFront View Rear View Interior Operation Panel Precautions Printer Setup Procedure before Operation Gori Connecting the Cables to Your Printer Connecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor position Batch mode Strip modeSTANDARD/PEEL OFF position Cut mode Build-in rewinder mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517 $5&2 Test Print Sample of the bar code test print label Operation Panel On Line Mode Operation Reset Dump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Optional Cutter Module Care/Handling of the Media and Ribbon Error Messages TroubleshootingError Messages Problems/Causes Solutions Restart key Possible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Do not use any tool that may damage the Print Head Removing Jammed Media Threshold setting procedure Threshold Setting Appendix 1 Specifications A1.1 PrinterModel A1.3 Media A1.2 OptionsA1.3.1 Media Type Label Label A1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes Figure below shows the effective print area on the media A1.4 Ribbon Appendix 2 Messages and Leds Symbols in the message Following message appears „Interface Cables Appendix 3 Interface Appendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digits CODE39 Full Ascii Industrial 2 UPC-A+5 digitsRSS-14 RSS-14 Stacked RSS Limited Bar code Glossaries USB Universal Serial Bus Print head element Index Index Page EO1-33034B