Toshiba B-SX4T Series, BSX4TGS20QMR owner manual Threshold Setting, Threshold setting procedure

5. TROUBLESHOOTING ENGLISH VERSION EO1-33034

5.4 Threshold Setting

5.4 Threshold Setting

NOTES:

1.If the [PAUSE] key is released within 3 seconds while in the pause state, the paper will not feed.

2.Failure to feed more than 1.5 labels may result in an incorrect threshold setting.

3.While the Print Head Block is raised, the [PAUSE] key does not work.

4.A paper end error cannot be detected during paper feed.

5.Selecting the Transmissive Sensor (for pre-printed labels) within software commands allows the printer to detect the proper print start position even when using pre-printed labels.

6.If using the Transmissive Sensor and the printer continues to print out of position even after setting the threshold, contact a TOSHIBA TEC service representative.

o maintain a constant print position the printer uses the Transmissive Sensor to detect the gap between labels by measuring the amount of light passing through the media. When the media is pre-printed, the darker %21/,1((or￿6;more￿7dense) 9inks￿￿￿can$interfere with this process causing paper jam errors. To get around this problem a minimum threshold can be set for the sensor in the following way.

T

	Threshold setting procedure
1.	%￿6;￿7			9￿￿￿$
	Turn the power ON. The printer is in stand by mode.
2.	state75. $160,66,9(
	Load a pre-printed media roll.
	%￿6;￿7			9￿￿￿$
3.	Press3$the86([PAUSE] key.
4.	The printer enters the pause mode.
5.	Press and hold the [PAUSE] key for at least 3 seconds in the pause
	%￿6;￿7			9￿￿￿$	Black mark sensor
6.	75$160,66,9(				Feed gap sensor
	The sensor type is displayed.
	%￿6;￿7			9￿￿￿$
7.	Select5()/(&7,9(the sensor to be adjusted by pressing the [FEED] key.
	[FEED]	key
				9￿￿￿$
8.	%￿6;￿7
	Press and hold the			[PAUSE] key until more than 1.5 labels (tags)
	have been issued.			9￿￿￿$
	%￿6;￿7
	The media will continue to be fed until the [PAUSE] key is
	released. (Threshold setting for the selected sensor is completed by
	this3operation.)$86(			9￿￿￿$
	%￿6;￿7
9.	Press21the/,1([RESTART] key.
10.	The printer is in stand-by.
11.	Send21an/,1(issue command from the PC to the printer.

E5- 4