3. Mode Setting
3.1 Input delay setting
The input delay time of the CD332 can be selected either normal or high speed mode. Refer to section 2.2 for the delay time of each mode.
The input delay setting is made by the jumper plugs provided on the CD332’s printed circuit board. This setting is applied for all 8 input points as a block.
CD332 left side
J9
A B A B
J10 J11
J1
J2
J3
J4
J5
J6
J7
J8
Set these jumper plugs as follows.
Mode | J1 | J2 | J3 | J4 | J5 | J6 | J7 | J8 | J9 | J10 | J11 |
Normal mode |
|
|
| ON | (short) |
|
|
| OFF | B | side |
High speed mode |
|
|
| OFF (open) |
|
|
| OFF | A side | ||
NOTE (1) The factory setting is the normal mode.
(2)Use a pair of tweezers to set the jumper plugs.
(3)J9 must be always OFF (open).
