Toshiba HD-XA2KN Preparation of the remote control, Open the cover Insert batteries

Chapter1Introduction

Preparation of the remote control

Set up the remote control to operate the player and your TV.

Loading batteries

1 Open the cover.

2 Insert batteries.

7Use 4 batteries (AAA sizes).

7Make sure to match the + and – on the batteries to the marks inside the battery compartment.

3 Close the cover.

Notes

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

Distance: About 7 m (23 ft) from the front of the remote sensor

Angle : About 30° in each direction of the front of the remote sensor

Do not drop or give the remote control a shock.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not disassemble the remote control.

Dispose of batteries in a designated disposal area.

Batteries should always be disposed of with the environment in mind.

Always dispose of batteries in accordance with applicable laws and regulations.

If the remote control does not operate correctly, or if the operating range becomes reduced, replace all batteries with new ones.

When necessary to replace batteries in the remote control, always replace all batteries with new ones. Never mix battery types or use new and used batteries in combination.

Be sure to use AAA size batteries.

Always remove batteries from remote control if they are dead or if the remote control is not be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.

Caution

Never throw batteries into a fire.

About the remote control backlight

The remote control has a backlight function for conveniently illuminating the buttons when you use the remote control in a dark room, etc.

Lights for approximately 10 seconds when a button is pressed.

The backlight function is off by default.

16

To turn on the backlight function

Press and hold for at least three seconds.

To turn off the backlight function, press and hold again for at least three seconds.

Notes

Using the backlight function shortens the lifespan of the batteries.

The backlight function turns off if the batteries in the remote control are replaced.