Chapter3Playback (Basic)

Powering on/Loading a disc

Turning the power on

 

1

Press

(front panel) or

 

(remote control).

 

 

ON/STANDBY indicator

ON/STANDBY button

ON/STANDBY button

When the power turns on, ON/STANDBY indicator on the front panel changes color from red (standby mode) to blue (operation).

Start up (and disc loading (see below)) may take time.

Note

When you power on this player for the fi rst time, the setting screen will appear. Please refer to page 52 and select “General” > “Clock Set”. Check the date and time are set properly and correct them if necessary. When complete, press SETUP to exit. Your player is ready.

Loading a disc

1

Press

(front panel) or

 

(remote control).

The player opens the disc tray.

2 Place a disc in the hollow of the disc tray with the playback side down.

When using a double-sided disc, turn the label of the playing side up.

After placing a disc, press OPEN/CLOSE.

Turning the power off

1 Press ON/STANDBY.

The power turns off and ON/STANDBY indicator on the front panel turns red (standby mode).

Note

If the player freezes for about 15 minutes or more and will not respond to any buttons, holding down ON/STANDBY button on the front panel for about 10 seconds can force the player to turn off. However, this is an emergency measure, which may cause damage to the player. Avoid casual use of this measure.

Notes

Use the button on the front panel or the remote control to open and close the disc tray. Do not push or hold the disc tray while it is moving. Doing so may cause the player to malfunction.

Do not load a disc which is unplayable, or any object other than a playable disc.

Do not apply downforce to the disc tray. Doing so may cause the player to malfunction.

If the disc tray stops while closing, the mechanical protection system of this player will open it. Do not force it to close. Doing so may damage the disc tray. If the disc tray will not open, turn the player off, and press OPEN/CLOSE on the front panel. This may turn the player on and open the disc tray. If it still won’t open, contact TOSHIBA Customer Support.

30

Page 30
Image 30
Toshiba HD-XA2KN owner manual Powering on/Loading a disc, Press Front panel or Remote control, Press ON/STANDBY