Toshiba M300 manual DC in icon, Procedure 2 Error Code Check

2 Troubleshooting Procedures

	Table 2-2 DC IN icon
DC IN icon	Power supply status
	DC power is being supplied from the AC adapter.
Lights blue or white
Blinks orange	Power supply malfunction*1
Doesn’t light	Any condition other than those above.

*1 when the power supply controller detects a malfunction, the DC IN icon blinks orange. It shows an error code.

When the icon is blinking, perform the following procedure.

1.Remove the battery pack and the AC adapter.

2.Re-attach the battery pack and the AC adapter.

If the icon is still blinking after the operation above, check the followings: Check 1 If the DC IN icon blinks orange, go to Procedure 2.

Check 2 If the DC IN icon does not light, go to Procedure 3.

Check 3 If the battery icon does not light orange or green, go to Procedure 4.

NOTE: Use a supplied AC adapter.

Procedure 2 Error Code Check

The following table lists the error codes and error status names.

Device Name	Error Code	Error Status Name
(Common)	FF	Data Compare Error
Memory	2	Protected Mode Not Changed
	??	Other Error
FDD	1	Bad Command Error
	2	Address Mark Not Found
	3	Write Protected
	4	Record Not Found
	6	Media Change Line Error
	8	DMA Overrun Error
	9	DMA Boundary Error
	0C	Select Media Error
	10	CRC Error
	20	FDC Error

Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08) ￿￿￿￿￿￿ 8