PORTÉGÉ M750

Installing a memory module (Slot A)

To install a memory module, follow the steps as detailed below:

1.Set the computer to Boot Mode and turn its power off - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 1, Getting Started, if required).

2.Remove the AC adaptor and all cables and peripherals connected to the computer.

3.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required).

4.Turn your computer over.

5.Open the display panel so that the screen faces directly upward.

6.Slip your finger under a notch at the end of the keyboard brace and lift up to release latches and remove the keyboard brace.

7.Remove two screws securing the keyboard.

Use a point size 0 Phillips screwdriver.

Keyboard brace

Screws

Figure 3-8 Removing the keyboard brace and two screws

3-26

User’s Manual