Manuals / Brands / Computer Equipment / Projector / Toshiba / Computer Equipment / Projector

Toshiba MP8640 5.3 Connection to the Control Signal Terminal

1 30

Download 30 pages, 800.37 Kb

Downloaded from Projector.com

© 3M 1997 3M™ Multimedia Projector MP8640

5.3 Connection to the Control Signal Terminal

ADB mouse

ADB port

D-sub 15pin (Female)

PS/2 mouse

PS/2 port

D-sub 15pin (Female)

a. Mouse emulation

(1) While the projector and computer are turned OFF, connect the projector and the mouse terminal of

computer using an appropriate cable. (PS/2, Serial or ADB)

(2) Turn ON the projector.

(3) Turn ON the computer.

(4) Select the correct mouse driver for the application. See computer's User Manual for this procedure.

Note: In some Notebook computers which have internal pointing device, mouse emulation will not work unless

the internal pointing device is disabled. In this case, disable the internal pointing device in BIOS setting.

Check the computer's manual for procedure to follow to disable internal pointing device in BIOS setting.

Caution: Turn off the power to both the projector and computer before connecting.

Connect the computer to the control terminal of the projector using the appropriate cable.

21

Contents

Main MP8640 Multimedia Projector Operator's Guide Table of Contents Safeguards SAVE THESE INSTRUCTIONS IMPORTANT SAFEGUARDS INTENDED USE Warranty THANK YOU FOR CHOOSING 3M LIMITED WARRANTY LIMITATION OF LIABILITY Section 1: Unpack 1.1 Contents of Shipping Box 1.4 What Next? 1.2 Optional Accessories 1.3 Keep Your Packaging Materials Section 2: Product Description 2.1 Machine Characteristics 2.2 Main Unit Identification 2.3 System Set Up - connecting various equipment 2.4 Remote Control Transmitter Identification Insert the provided batteries (AA or R6P) into the remote control transmitter. How to insert batteries: 1. Remove the battery compartment cover. 2. Insert the batteries as illustrated inside the battery compartment. 3. Replace the cover. Section 3: Basic Operations 3.1 Installation 1 2 3 4 5 6 Page Section 4: Adjustment and Functions 4.1 Menu 1 projector or remote control MENU button. 2 STICK SWITCH. 3 4.2 How To Use Foot Adjusters Front view Side view 4.3 SETUP The menu SETUP is used to adjust the image and to move the image position. 4.4 INPUT The menu INPUT is used to select the input source. SYSTEM 4.5 IMAGE The IMAGE menu is used to alter the image. 4.5 IMAGE (continued) 4.6 OPT The OPT. menu allows you to control communication function. SETUP INPUT IMAGE OPT. COM. SPEED COM. BITS TIMER LANGUAGE AUTO OFF STARTUP Selection COM. SPEED COM. BITS TIMER LANGUAGE AUTO OFF START UP Description Section 5: Connection to Signal Terminals 5.1 Connection to the Video Signal Terminal b. Signal input terminal / output terminal a. Input signal b. Signal input terminal c. Example of computer signal 5.3 Connection to the Control Signal Terminal a. Mouse emulation 5.3 Connection to the Control Signal Terminal (continued) b. RS 232 Control Cable (not included with basic packout) Section 6: Maintenance 6.1 Cleaning the Air Filter 6.2 Message Table 6.3 Lamp Replacing the Lamp Display Lamp Operation Hours Symptom Cause 6.4 When You Think Something Is Wrong Check the following table before asking for service. If a solution cannot be found, consult dealer. Section 7: Technical Specifications 7.1 Specifications 7.2 Accessories