Power and Power-up Modes

Replacing the battery pack

Please be aware that the battery pack is classified as a consumable item.

The operating life of the battery pack will gradually reduce through repeated charging and discharging, and will need to be replaced when it reaches the end of its operating life. In addition to this, you might also replace a discharged battery pack with a charged spare when you are operating your computer away from an AC power source for an extended period of time.

This section explains how to remove and install the battery pack, and begins with the removal process which is detailed through the following steps.

■Do not remove the battery pack while the computer is in Sleep Mode.

Data is stored in RAM, so if the computer loses power it will be lost.

■In Hibernation Mode, data will be lost if you remove the battery pack or disconnect the AC adaptor before the save is completed. Wait for the Hard Disk Drive indicator to go out.

■Do not touch the battery release latch while holding the computer or the battery pack might fall out due to the unintentional release of the battery release latch and cause injuries.

To remove a discharged battery, follow the steps as detailed below:

1.Save your work.

2.Turn the computer's power off - ensure that the Power indicator is off.

3.Remove all cables and peripherals that are connected to the computer.

4.Close the display panel and turn the computer upside down.

5. Slide the battery safety lock towards the release (

) position to make

the battery release latch movable.

 

User’s Manual

6-9