Manuals / Brands / Computer Equipment / Laptop / Toshiba / Computer Equipment / Laptop

Toshiba R800, R830, R840, R850 Monitoring of power condition, not, DC IN, DC IN, Power, Green, Orange, Battery, Battery, Battery, Battery, Power on, No light, Power off, connected, DC IN off

1 214

Download 214 pages, 8.07 Mb

		Power on	Power off
			(no operation)
AC adaptor	Remaining	• Operates
not	battery capacity is	• LED:
connected	above low battery	Battery off
	trigger point	Battery off
	trigger point	DC IN off
		DC IN off

	Remaining	• Operates
	battery capacity is	• LED:
	below low battery	Battery
	trigger point	Battery
	trigger point	flashes orange
		flashes orange
		DC IN off

	Remaining	Computer shuts
	battery capacity is down
	exhausted

	No battery
	installed	• No operation

• LED: Battery off DC IN off

Monitoring of power condition

As shown in the below table, the Battery, DC IN and Power indicators on the system indicator panel alert you to the computer’s operating capability and battery charge status.

Battery indicator

Check the Battery indicator to determine the status of the battery pack. The following indicator lights indicate the battery status:

Flashing orange	The battery charge is low, the AC adaptor must be
	connected in order to recharge the battery.

Orange	Indicates the AC adaptor is connected and the
	battery is charging.

Green	Indicates the AC adaptor is connected and the
	battery is fully charged.

No light	Under any other conditions, the indicator does not
	light.

User’s Manual

5-2

Contents

Page Preface General Precautions Chapter Getting Started Chapter 2 The Grand Tour Chapter 4 Utilities & Advanced Usage Chapter 5 Power and Power-UpModes Troubleshooting Appendix A Specifications Appendix B AC Power Cord and Connectors Copyright Disclaimer Trademarks FCC information EU Declaration of Conformity VCCI Class B Information Video Standard Notice Canadian regulatory information (Canada only) Following information is only valid for EU-memberStates: Disposing of the computer and the computer's batteries REACH - Compliance Statement Following information is only for Turkey: Optical disc drive safety instructions ■DVD SuperMulti with Double Layer UJ8A2 2.TOSHIBA SAMSUNG STORAGE TECHNOLOGY ■ DVD SuperMulti with Double Layer TS-U633J Precautions Preface Conventions Display ABC presented in the type face you see to the left Messages Terminology This term is defined in this document as follows: Page General Precautions Provide adequate ventilation Creating a computer-friendlyenvironment Stress injury Heat injury Pressure or impact damage ExpressCard overheating Mobile phones Instruction Manual for Safety and Comfort Getting Started Equipment checklist Getting Started Connecting the AC adaptor ■Do not use a 3-pinto 2-pinconversion plug Page Opening the display ■Do not press or push on the display panel ■Do not lift the computer by the display panel Turning on the power ■Volume cannot be adjusted during Windows Setup 1.Open the display panel Starting up for the first time order to properly install the operating system When it is displayed, be sure to read the Software License Terms carefully Turning off the power Shut Down Mode 2.Make sure all disk/disc activity has stopped before removing the disk/disc Benefits of Sleep Mode Executing Sleep Mode Sleep Mode limitations Benefits of Hibernation Mode Starting Hibernation Mode Automatic Hibernation Mode Data save in Hibernation Mode achieved: Restart Press ALT DEL The Grand Tour The Grand Tour for R850 Page Hard Disk The Hard Disk Drive/Optical Disc Drive/eSATA Drive/Optical Disc indicator Drive/eSATA The AC adaptor connects to this jack in order to power the computer and charge its internal can cause damage to the computer The cooling vents help the processor to avoid overheating External RGB This port provides 15-pin,analog VGA port monitor port Please refer to Appendix A for information on external RGB monitor port pin assignment Headphone /Microphone jack (USB 2.0) ports eSATA/USB combo Optical disc drive This jack lets you connect to a LAN. The adaptor per second, 10BASE-T),Fast Ethernet LAN (100 megabits per second, 100BASE-TX)or Gigabit Ethernet LAN (1000 megabits per second 1000BASE-T).Refer to chapter 3, Operating Legal Footnote (Battery Life) Underside (R850) Docking port Front with the display open (R850) Page ■HD+, 1600 horizontal x 900 vertical pixels ■HD, 1366 horizontal x 768 vertical pixels Legal Footnote (LCD) Web Camera LED The Web Camera LED glows when the Web Legal Footnote (Wireless LAN) Wireless WAN WiMAX antennas Bluetooth antenna eco button The Grand Tour for R840 Page Left side (R840) (USB 2.0) port Headphone jack Right side (R840) Operating Basics The USB port type may vary depending on the model you purchased. The Port with blue color is USB 3.0 port The USB 2.0 port is compliant with USB Back (R840) Underside (R840) Page Front with the display open (R840) Page Page access it, click Start ->Control Panel ->System and Security ->Power Options The Grand Tour for R830 Page Left side (R830) Right side (R830) Page Page Back (R830) Underside (R830) Page Front with the display open (R830) Page Page Page Internal Hardware Components Hard Disk Drive or Solid State Drive on the model Please note that part of the hard disk's overall capacity is reserved as administration space Display controller Graphics controller The graphics controller maximizes display performance Graphics controller Legal Footnote (Graphics Processing Unit ("GPU")) Intel® Display Power Saving Technology (R850 & R840) Intel® Display Power Saving Technology (R830) AMD® Vari-Bright™ PowerPlay Enable Vari-Bright Operating Basics TOSHIBA Dual Pointing Device Using the AccuPoint Using the Touch Pad Some models are equipped with an AccuPoint AccuPoint precautions ■You touch the AccuPoint during power-up The Keyboard Function keys: F1 … F12 F12 Soft keys: FN key combinations FN + F10 FN + F11 (ScrLock) to lock the cursor on a specific line. The is off ScrLock ■Press FN + ENTER to simulate ENTER on the enhanced keyboard’s numeric keypad To access this help, click Hot keys This section describes the associated functions of the hot keys ■Mute Pressing FN + ESC turns the volume on and off Arrow Mode Numeric Mode Using the Fingerprint Sensor How to Swipe your Finger Points to note about the Fingerprint Sensor Do not scratch or poke the sensor with your nails or any hard or sharp objects ■Do not press the sensor strongly ■Do not paste stickers or write on the sensor Do not touch the sensor with a finger or any other object which may have a ■The recognition success rate may differ from user to user Points to note about Fingerprint Utility ■Please use Import/Export on TOSHIBA Fingerprint Utility main menu . The main screen is displayed. Click in the lower left corner of the screen ■The recognition success rate may differ from user to user Setup Fingerprint Registration Please use the following procedure when first using fingerprint authentication , or click the Fingerprint utility icon in the Taskbar Enroll Windows Password Next ■It is strongly recommended that you register 2 or more fingerprints 5.Click Close Close "Are you sure you want to quit?" is displayed. Click Delete all users fingerprints In the Fingerprint boot authentication and Single Sign-onfeature Overview about Fingerprint boot authentication Overview about Fingerprint Single Sign-onfeature How to Enable Fingerprint boot authentication and Single Sign-Onfeature 1.Logon as Administrator (means a user has administrator privileges) Optical disc drives Page Page Removing discs How to remove disc when the disc tray will not open Writable discs CDs CD-R DVDs DVD-R Writing discs Important message Disclaimer Before writing or rewriting CD-R: CD-RW: (Multi-Speed, High-Speedand Ultra-Speed) DVD-R: DVD Specifications for Recordable Disc for General Version DVD-RDL: ■Do not perform any of the following actions: ■Change users in the Operating Systems ■Start a communication application such as a modem ■Apply impact or vibration to the computer ■Use the audio/video control button to reproduce music or voice ■TOSHIBA Disc Creator cannot record in packet format If you add data to a TOSHIBA Disc Creator does not support recording to When you back up a ■You cannot partially delete any data written to a CD-RW, DVD-RWor DVD+RW disc TOSHIBA VIDEO PLAYER Display Devices & Audio Starting TOSHIBA VIDEO PLAYER Wireless communications ■Frequency Channel Selection of 5GHz for IEEE 802.11a or/and IEEE802.11n ■Frequency Channel Selection of 2.4GHz for IEEE 802.11b/g or/and IEEE802.11n ■Roaming over multiple channels ■Card power management Wired Equivalent Privacy (WEP) data encryption based on an Form Factor PCI Express Mini Card Compatibility ■ IEEE 802.11 Standard for Wireless LANs ■ Wi-Fi(Wireless Fidelity) certified by the Wi-Fi LAN This section describes how to connect/disconnect to a LAN Do not install or remove a memory module while Wake-upon LAN is enabled LAN cable types Connecting the LAN cable To connect the LAN cable, follow the steps as detailed below: Optional devices ExpressCard Smart Card Memory media slot Memory media Media care Inserting a memory media Removing a memory media Additional memory module Installing a memory module 8. Seat the memory module cover in place and secure it with the screw(s) Removing a memory module External monitor Connecting the monitor cable HDMI When you unplug the HDMI cable and When you change the display output device by hot key like a.Click Start ->Control Panel ->Hardware and Sound ->Sound b.In the Playback tab, select the playback device which you want to switch to To use the internal speakers on your computer, select DisplayPort eSATA (External Serial ATA) devices Connecting the eSATA device Make sure the connector is properly aligned with the socket Do not try to force the connection, doing so can damage the connecting pins Disconnecting an eSATA device When you have finished using an eSATA device, you can follow the TOSHIBA Hi-SpeedPort Replicator Security lock Optional TOSHIBA Accessories Sound System Video mode Computer Handling Heat dispersal Utilities & Advanced Usage Utilities and Applications Function Fingerprint Utility TOSHIBA Face Recognition TOSHIBA VIDEO Bluetooth Stack for Windows by Toshiba TOSHIBA Assist All Programs - > TOSHIBA TOSHIBA ConfigFree TOSHIBA DVD-RAM This utility has the function of Physical Format and Write-Protectto DVD-RAM.This utility is contained the setup module of TOSHIBA Disc Creator. To start this utility, click Start ->All Programs TOSHIBA Media This application allows you to control your music Controller pictures and videos by streaming content to any compatible device in your home Special features Instant security Intelligent power supply*1 in the Power Options Low battery automatic Hibernation Mode*1 Using the TOSHIBA Sleep Utility function (hereinafter called "compatible ports") Compatible ports are USB ports that have the () symbol icon Starting the TOSHIBA Sleep Utility To start the utility, click Using the TOSHIBA Face Recognition ■TOSHIBA Face Recognition can be used only in Windows Vista and Windows Disclaimer How to register the Face Recognition Data steps as described below: To launch this utility, click Registration Management in lower left of the as described below: . The 2.Select a user which is displayed in the Management screen Delete If you do not want the data to be deleted, click the TOSHIBA Password Utility ■To start BIOS Setup; 1. Turn on the computer 2.Press the F2 key when the TOSHIBA Leading Innovation >>> screen appears key when the screen appears HW Setup Setup Power On Display Dynamic CPU Frequency Mode Boot Priority Options USB Memory BIOS Support Type Panel Open - Power On Wake-upon Keyboard Wake-upon LAN Built-inLAN Legacy USB Support eSATA SATA Interface setting TOSHIBA PC Health Monitor Using the Hard Disk Drive (HDD) Protection TOSHIBA HDD Protection Properties System Recovery You can also create recovery media and restore the system The following items will be described in this section: ■System Recovery Options ■Creating Recovery Media ■Restoring the pre-installedsoftware from your created Recovery Media ■Do not use on an unstable surface such as a stand 1.Select either blank DVD or USB Flash Memory Double click the Recovery Media Creator Create 2.Turn off the computer's power While holding down Boot Setting A menu will be displayed from which you should follow the All Programs Triple/Quad Multi Monitor Quad Multi Monitor Power and Power-UpModes Power conditions Monitoring of power condition Battery Real Time Clock (RTC) battery S **** RTC Power Failure Check system. Then press [F2] key Troubleshooting Care and use of the battery pack Charging the batteries You must recharge a battery pack when it becomes discharged Procedures Time Refer to User Information Guide about Charging time ■The battery has not been used for a long time ■A cool battery is installed in a warm computer In such cases you should follow the steps as detailed below: 3.Charge the battery until the Battery indicator glows green Monitoring battery capacity ■Where you store your programs and data ■The environmental temperature - operating time decreases at low temperatures Batteries exhausted time Refer to User Information Guide about Retaining time Extending battery life Replacing the battery pack Please be aware that the battery pack is classified as a consumable item Removing the battery pack To remove a discharged battery, follow the steps as detailed below: 1.Save your work Power-upmodes Panel power on/off System automatic Sleep/Hibernation Troubleshooting Problem solving process Analyzing the problem Software Hardware If something goes wrong Your program stops responding Start Task Manager Hardware and system checklist Problem Procedure AC power Battery Power saver Select a power plan in the Power Options Real Time Clock ProblemProcedure System Date System Time F10 Hard disk drive Optical Disc Drive Memory Media Card Smart Card Dual Pointing device Touch Pad/AccuPoint Click Start ->Control Panel ->Hardware and Sound ->Mouse Panel ->Hardware and Sound ->Mouse USB mouse On-screenpointer does not respond to mouse operation Double-clickingdoes In this instance, you should initially try changing the not workdouble-click speed setting within the Mouse Control utility To access this utility, click Fingerprint Sensor USB device Sleep and Charge function Page eSATA device Additional memory module If there is an error in only Slot A: orange twice, then green once If there is an error in only Slot B: orange once, then green twice If there are errors in both Slot A and Slot B:orange twice, then green twice 1.Disconnect the AC adaptor and all peripheral devices External monitor LAN Bluetooth TOSHIBA support Specifications Physical Dimensions Environmental Requirements Power Requirements External RGB monitor port pin assignment AC Power Cord and Connectors Certification agencies USA United Kingdom AustraliaEurope Canada China Legal Footnotes Non-applicableIcons CPU Memory (Main System) Battery Life Hard Disk Drive (HDD) Capacity LCD Graphics Processing Unit ("GPU") Wireless LAN Copy Protection Information for Wireless Devices Wireless LAN Interoperability Bluetooth wireless technology Interoperability CAUTION about Wireless Devices Wireless Devices and your health Radio Regulatory Information Europe Restrictions for Use of 2400.0-2483.5MHzFrequencies in Europe Luxembourg: Russian Federation: Restrictions for Use of 5470-5725MHzFrequencies in Europe Canada - Industry Canada (IC) USA-FederalCommunications Commission (FCC) Refer to the FCC information section for the detailed information Caution: Exposure to Radio Frequency Radiation Caution: Radio Frequency Interference Requirements Taiwan Article Using this equipment in Japan 1. Important notice Device Authorization Page Radio approvals for wireless devices Page Page Page Page Page Page Page Approved Countries/Regions for BCM92070MD_REF Bluetooth Page Glossary AC: ANSI: AMT: ASCII: IEEE: I/O: IRQ: KB: LAN: