| Owner’s Manual |
Operation section
Push each button to select a desired operation.
•The control saves commands in memory and after the initial setting, there is no need for any additional settings
unless changes are desired. The air conditioner can be operated by pushing the 
button.
1 8
12 |
2 |
5 |
3 |
1 
button
Selects the desired Fan speed.
2
button
Use to setup the timer.
3
button
Use only for service.
(During normal operation, do not use this button.)
4 
button
Use when a power ventilation kit (commercially- supplied) is connected.
•If “ ” is displayed on the remote control when pushing the Ventilation button, no vent kit connected.
5
button
Resets “ 
” display after cleaning filter.
6 
button
Use to initiate power saving mode.
7
button
Use to select automatic swing or fixed louver position.
9
10
4 6
11
7
9
button
When the button is pushed, the operation starts, and it stops by pushing the button again.
When the operation has stopped, the operation lamp and all the displays disappear.
10
button
Selects desired operation mode.
11
button
Selects a unit number (left) and louver number (right).
UNIT :
Selects an indoor unit when adjusting louver direction when multiple indoor units are controlled with one remote control.
LOUVER :
Selects a louver when setting louver lock or louver direction adjustment independently.
12 
button
Adjusts the set point.
Select the desired set point by pushing 
TEMP.
or 
TEMP. 
.
8 Operation lamp
Green light illuminates when unit is on.
Although it flashes when operating the protection device or an error occurs.
OPTION :
Remote control sensor
Usually the temperature sensor of the indoor unit senses the temperature. The temperature on the surrounding of the remote control can also be sensed. For details, contact the dealer from which you have purchased the air conditioner.
– 9 – |
