| Owner’s Manual |
Louver lock (No swing)
3 |
4 |
2 1
1 Push 
(right side of the button) for at least four seconds when the air conditioner is not working.
• 
and numbers flash.
2 Push 
(left side of the buttom) to select an indoor unit to be set.
•Each time you push the button, unit numbers change as follows:
The fan of the selected unit runs and the louvers start swinging.
UNIT No. |
| UNIT No. |
| UNIT No. |
|
|
UNIT No. 
3 Push TEMP. 
buttons to display the number of a louver you want to lock on the temperature display.
• The selected louver starts swinging.
CAUTION
•If (4) or (5) is selected, condensation may drop from the unit during operation in cooling mode.
5 Push 
button to lock the louver.
•When the setting has been determined, 
lights up.
(To continue louver lock settings for other indoor units, repeat from step 2. To continue louver lock settings for other louvers on the same indoor unit, repeat from step 3.)
6 Push 
button to complete the setting.
(Louver lock position code)
4 Push TIME 
buttons to select the louver direction of the louver you do not want to swing.
SET DATA | (1) | (2) | (3) |
| 0001 | 0002 | 0003 |
(4)(5)
0004 0005
•A louver number is displayed as F1, F2 on the remote control (SET DATA), showing that louver 01, 02 shown in the figure on the previous page is selected.
NOTE
Even when louvers are locked, they move temporarily in the following cases:
•When the air conditioner is stopped
•At the beginning of heating operation
•During defrosting operation
•When the room temperature has reached the set temperature
EN |
– 18 – |
