Owner’s Manual |
6. CORRECT USAGE
•When you use the air conditioner for the first time or when you change the setting, follow the steps below.
Settings are saved in memory and are displayed anytime the unit is turned on by pushing the 
button.
Preparation
• When the circuit breaker is turned on, the partition lines are displayed on the remote control.
*After the circuit breaker is turned on, the remote control does not accept any commands for approx. 1 minute, this is not a failure.
REQUIREMENT•When you
TEMP. |
|
| ON / OFF |
| 1 |
4 |
|
|
| 3 | |
|
|
| 2 | ||
| TIMER SET | FAN | MODE | ||
| TIME | SAVE | VENT |
| |
FILTER | SET CL | SWING/FIX | UNIT LOUVER |
|
|
RESET TEST |
|
|
Start
1 Push 
button.
The operation lamp illuminates, and the operation starts.
2 Select an operation mode with the “ 
” button.
One push of the button, and the display changes in the order shown below.
AUTO 
HEAT 
DRY 
COOL 
FAN
3 Select fan speed with “ | ” button. |
One push of the button, and the display changes in the order shown below.
AUTO 
HIGH
MED..
LOW 
•When fan is in “ 
AUTO”, fan speed is adjusted based on difference between set point and room temperature.
•In heating operation, if the room temperature is not heated sufficiently with volume “ 
LOW”
operation, select “
MED.” or “ 
HIGH” operation.
•The temperature sensor detects the return air temperature at the indoor unit, which differs from the room temperature depending on the installation condition.
Set point is a target of room temperature.
( 
“AUTO” is not selectable in the FAN mode.)
4 Select the set point temperature by pushing the “TEMP. 
” or “TEMP. 
” buttons.
Stop
Push
button.The operation lamp goes off, and the operation stops. In the COOL, DRY, or AUTO (cooling) mode, the fan runs for 10 minutes (or more) for self cleaning.
EN |
– 10 – |
