Basic setup
Setting the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a program selected by the VCR's channel selector, the TV must be set to channel 3 or 4 (video channel).
Setting the video channel
POWER
3
4
TV/VCR VCR DVD
1 Press and hold 3 or 4 on the remote for 3 seconds in standby mode.
The video channel will
3 OR 4 start to flash for 3 seconds in the display window.
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot be tuned on your TV, proceed as follows: set the VCR 3/4 channel selector and the TV to CH 3 or 4, play back a prerecorded tape and tune the TV to receive a sharp color picture from the video cassette recorder. Refer to your TV owner's manual for details.
Note:
If the unit does not operate properly, or No key operation (by the unit and/or the remote control): Static electricity, etc.,
may affect the player's operation. Disconnect the AC power cord once, then connect it again.
TV/VCR | The VCR indicator will | |
| appear in the display | |
| window. | |
|
|
|
|
|
|
|
|
|
6 Select any channel to receive a TV station in your area. The channel number will appear on the screen for about 4 seconds.
22
2C53301C | 22 |
21/4/04, 11:10
