Advanced Operation
Call Forward
Call Forward Procedures
The following table contains Call Forward Button sequences. You can do a Call Forward function by one, entering the button sequence as described, or two, programming a flexible button to perform the sequence. See “Call Forward Procedure” on page 12 for instructions on programming a flexible button.
Some Call Forward features require a Pass Code entry. Use the following procedure to change your Pass Code.
➤To change your Pass Code
➤Lift the handset, press + ext. no. + old Pass Code (1~15 digits) + + new Pass Code (1~15 digits) + .
➤To use the Call Forward button sequence
➤Follow the instructions in the following table, shown under “Button Sequence.” Some features require additional input, such as:
•Destination – If the destination is an outside number, press after entering the destination. The CTX accepts destination numbers of up to 32 digits.
•Timer – This is a two digit entry representing how long (8 to 160 seconds) your telephone should ring before forwarding the call. If you enter one digit, you must press after entering the single digit.
•Pass Code – A
Note In the following table, (Tone) means that a confirmation tone will play at that point in the sequence.
Table 1 Call Forward Procedure
Feature |
| Button Sequence |
Call Forward Any Call (Internal and Incoming Line) | ||
All Calls | Lift handset, press | (Tone) + Destination No. + (Tone) |
|
|
|
Busy | Lift handset, press | (Tone) + Dest. No. + (Tone) |
|
|
|
No Answer | Lift handset, press | (Tone) + Dest. No. + (Tone) + Timer + |
|
|
|
Busy No Answer | Lift handset, press | + Dest. No. + + Timer + |
|
| |
Cancel | Lift handset, press (Tone) | |
|
|
|
12 | Strata CTX Standard Telephone 05/02 |
