Using the document camera (Continued)
■Image projection with the document camera
1 Press the LED LIGHT button.
The illumination LED lights.
CAUTION
•Please do not look into the lighting LED directly. The strong light may cause damage to the eyes or sight.
2Place the document.
Set the document at the side of the projector.
3 Press the CAMERA button, and select camera input.
• The input returns to the previous input when the CAMERA button is pressed again.
• Camera input can also be selected by pressing either the remote control or projector’s INPUT button.
4Rotate the camera head to align the orientation of the document for shooting by checking the screen.
5Move the camera arm up and down to adjust the image size.
Farther: Smaller image
Closer: Larger image
43 cm
• When projecting the document of A4 size (210 mm ⋅ 297 mm), please adjust the height of the camera head to about 43 cm.
Notes
•You can use the RESIZE function of the remote controller to change the size of an image. p.30
•In the camera input mode, the image may disappear for a moment. This is not a problem.
7 | If the screen is too dark or too bright, use the CAMERA | Operations |
6 | Adjust the focus with the focusing ring of the camera |
|
head.
Adjust by rotating the focusing ring of the camera head until the projected image becomes clear.
GAIN
8Fold up the camera using the reverse order from
unfolding the document camera.
Fold up with the reverse steps of “Preparation of the document camera”.
PRECAUTION
• If the room's fluorescent lighting causes the image to flicker, either change the Shutter setting of shutter speed by 50/60Hz switch, or turn off the fluorescent light. Note that changing the Shutter setting may not eliminate the flicker, depending on the state of lighting, document or image adjustment.
Note
• There is no audio output when the camera input is selected.
46 | 47 |
