
APPENDIX
LAMP REPLACEMENT
When life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a projected image becomes dark or color of an image becomes unnatural, replacement of Projection Lamp is required.
|
|
|
|
|
|
|
|
|
|
|
| CAUTION |
|
|
| CAUTION |
|
|
|
| For continued safety, replace with a lamp |
|
|
| Do not drop a lamp assembly or touch a glass |
|
|
|
| assembly of same type. |
|
|
| bulb! Glass can shatter and may cause injury. |
|
|
|
| Allow a projector to cool for at least 45 |
|
|
|
|
|
|
|
|
|
| ||||
|
|
| minutes before you open Lamp Cover. Inside |
|
|
|
|
|
|
|
| of a projector can become very hot. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Follow these steps to replace lamp assembly.
1 | Turn off a projector and disconnect AC plug. Allow a projector to |
cool for at least 45 minutes. | |
2 | Loosen 2 screws with a screwdriver and open Lamp Cover. |
3 | Loosen 2 screws with a screwdriver and pull out Lamp Assembly |
by grasping Handle. | |
4 | Replace Lamp Assembly with a new one and tighten 2 screws |
back. Make sure that Lamp Assembly is set properly. Replace | |
| Lamp Cover and tighten 2 screws. |
5 | Connect AC Power Cord to a projector and turn it on. |
6 | Reset Lamp Replace Counter (refer to section “Lamp Replace |
Counter” below). |
NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced.
| LAMP COVER |
LAMP | HANDLE |
ASSEMBLY |
|
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give following information to dealer.
● Model No. of your projector :
●Replacement Lamp Type No. : TLPLX40
LAMP REPLACE COUNTER
Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP REPLACE Indicator stops lighting.
1 | Turn projector on, press MENU button and |
| move a red frame pointer to SETTING Menu icon (refer to page 39). |
2 | Press POINT DOWN button to move a red frame pointer to “Lamp counter reset” and then press SELECT button. |
| Message "Lamp replace counter reset?" is displayed. Move pointer to [Yes] and then press SELECT button. |
3 | Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter. |
Do not reset Lamp Replace Counter except after Projection Lamp is replaced.
41