Bass level
Adjustment ItemDisplay

Range

Bass Center Frequency

"BAS F"

40/50/60/70/80/100/

 

 

120/150 Hz

Bass Q Factor

"BAS Q"

1.00/1.25/1.50/2.00

Bass Extend

"B EX"

OFF/ON

Middle level

 

 

Adjustment Item

Display

Range

Middle Center Frequency

"MID F"

0.5/1.0/1.5/2.0 kHz

Middle Q Factor

"MID Q"

1.0/2.0

Treble level

 

 

Adjustment Item

Display

Range

Treble Center Frequency

"TRE"

10.0/12.5/15.0/17.5 kHz

5Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second.

•When you set the Bass Extend to ON, low frequency response is extended by 20%.

•You can exit the Audio Control mode at anytime by pressing any button except for [VOL] and the [ATT] buttons.

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass Filter

"HPF"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Rear High Pass Filter

"HPR"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Low Pass Filter*1,2

"LPF"

50/60/80/100/120/

 

 

Through Hz

Subwoofer Phase*1,2,3

"PHAS"

Reverse (180°)/ Normal (0°)

Volume offset

"V-OFF"

–8 — ±0

Loudness

"LOUD"

OFF/ON

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

•*1 You can control this item when <Switching preout> (page 21) is set to "SWPRE SW".

•*2 You can control this item when <Subwoofer Output> (page 11) is set to "SW ON".

•*3 You can control this item when Low pass filter is not set to Through.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

English 9