43
13. Turbo preparation
1. TURBO PROTECTION.
CAUTION:Cover all the inlet and outlet holes with
protective tape to avoid parts from
falling in.
2. REMOVE PLATE WITH PRESSURE ACTUATOR.
(a) Remove the pressure actuator bracket by removing
the clip and 2 bolts.
R: Clip
R: Bolt (2 pcs.)
R: Pressure actuator.
K: Turbo charger (3-1)
CAUTION:Do not damage nu t assurance.
3. TURBO LUBRICATION.
(a) Insert some engine oil into the oil return outlet side of
the turbo and rotate the turbo turbine axle a few times
to lubricate the axle bearings.
CAUTION:Close the inlet hole with tape to avoid
parts from falling in.
4. INSTALL WATER ADAPTERS.
(a) Install the water outlet (2) adapter (16/16mm).
K: Outlet adapter No.1 (17-4)
Torque: 70 Nm
NOTICE:The boss-side of the adapter is facing the
turbo housing side.
(b) Install the water inlet adapter (14/16mm).
K: Inlet adapter No. 2 (16-2)
Torque: 50 Nm
R
R
R
R
K
K K
12