Toyota pmn instruction manual Installation engine compartment upper, Install Turbo Inlet Pipe

53

16. Installation engine compartment upper

	K
K	K
K

1. INSTALL TURBO INLET PIPE.

(a)Position the turbo inlet pipe, hose and 2 clamps. K: Pipe, Airbox turbo (2-2)

K: Hose (2-4)

K: Clamp (2 pcs.) (2-1)

(b)Tighten outer hose clamp on turbo charger side.

(c)Pull inlet pipe 5 mm out of the hose and hand tighten inner clamp.

K

K

K

K

K

K

K

2. INSTALL TURBO INLET PIPE BRACKET.

(a)Install the bracket with the 2 bolts onto the inlet pipe. K: Bolt (2 pcs.) (2-10)

K: Bracket (2-3)

Torque: 9 Nm

(b)Position the bracket and fix the bracket to the cylinder head with a bolt, washers and nut.

K: Bolt (2-6)

K: Nut (2-8)

K: Washer (2 pcs.) (2-7)

Torque: 25 Nm

(c)Tighten the inner clamp of the inlet pipe hose. Torque: 3 Nm

K
2
K	K
K	2

3. INSTALL WATER HOSE CLAMP

(a)Install the water hose with the clamp to the turbo inlet pipe.

K: Clip (17-6)

4. INSTALL VSV T-JUNCTION.

(a)Cut the vacuum hose 2 and insert the T-junction.

(b)Install the clamps onto the vacuum hoses. K: Clamp (2 pcs.) (25-3)

K: T-Junction (25-2)

Torque: 3 Nm

(c)Install the vacuum hose 2 onto the VSV using the clamp.

R: Clamp.