TD-W8950ND 150Mbps Wireless N ADSL2+ Modem Router User Guide
) Note:
To completely configure the WAN Interface, you need to first select the Layer2 Interface (4.4.1
Layer2 Interface) according to the connection ISP provides you, and then to select the type of the
connection (4.4.2 WAN Service) for the further configuration.
4.4.1 Layer2 Interface Choose “Advanced Setup”Æ“Layer2 Interface”, and you can select WAN Service Interface
(layer2 interface) over ATM interface or ETH interface.
¾ ATM Interface: Configure the modem router to access Internet as an ADSL user. ISP
provides you VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL
Interface with RJ11 connector. (Figure 2-1)
¾ ETH Interface: Configure the modem router to access Internet as an Ethernet user. ISP
provides you Broadband Internet Service and the Ethernet Interface with RJ45 connector.
4.4.1.1 ATM interface
Choose “Advanced Setup”Æ“Layer2 InterfaceÆATM interface”, you can Configure ATM
interfaces on the screen below.
Figure 4-2
¾ Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.
) Note:
If the interface is used by the configuration of the 4.4.2 WAN Service, you need to remove the
corresponding WAN Service entry first before you can remove it here.
¾ Add: Click the button, and you can add a new interface in the next screen.
19