TD-W8950ND 150Mbps Wireless N ADSL2+ Modem Router User Guide
last one the lowest priority if the WAN interface is connected. Priority order can be changed by
removing all and adding them back in again.
4.4.10.2 Static Route
Choose “Advanced Setup”Æ“Routing”Æ“Static Route”. You can see the Static Route screen,
this screen allows you to configure the static routes (shown in Figure 4-51). A static route is a
pre-determined path that network information must travel to reach a specific host or network.
Figure 4-51
To add static routing entries:
1. Click the Add button in Figure 4-51, and you will see the screen as shown in Figure 4-52.
Figure 4-52
2. Enter the following data:
¾ IP Version: Select the version of IP.
¾ Destination IP Address: The Destination IP Address is the address of the network or host
that you want to assign to a static route.
¾ Interface: Select the Interface name in the text box, or else, the default Use Interface will be
adopted for the Static Route.
¾ Gateway IP Address: If you select the IPoE or IPoA mode for Interface, the screen above
will display this item, you should type the Gateway address correctly, and the other option for
Interface will adopt the default Gateway address for the Static Route.
3. Click Save/Apply to make it take effect and then you will see you settings as shown in Figure
4-51.
50