TP-Link TL-SG5412F Rear Panel, Port Feature, 10/100/1000Mbps RJ45 Port, SFP Port, Console Port

L2 Managed Switch

Port Feature

Model	10/100/1000Mbps RJ45 Port	SFP Port	Console Port
TL-SG5428	24	4	1
TL-SG5412F	4	12	1

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. For TL-SG5428, each 10/100/1000Mbps RJ45 port has a corresponding 1000Mbps LED and Link/Act LED. But for TL-SG5412F, each 10/100/1000Mbps RJ45 port has a corresponding 10/100/1000BASE-T LED.

SFP Port

Designed to install the SFP module. The SFP ports of these two devices support 1000Mbps SFP module connection only. Each has a corresponding 1000Mbps LED and Link/Act LED.

Console Port

Designed to connect with the serial port of a computer or terminal for monitoring and configuring the Switch.

■■ Rear Panel

Due to the similarity of TL-SG5428 and TL-SG5412F in the rear panel, here TL-SG5428 is used as an example.

Grounding Terminal

Power Socket

FFFFFFFFFFFFRear Panel of TL-SG5428

Grounding Terminal

The Switch already comes with lightning protection mechanism. You can also ground the Switch through the PE (Protecting Earth\ cable of AC cord or with Ground Cable. For detailed information, please refer to Chapter 3 Lightning Protection.

Power Socket

Connect the female connector of the power cord here, and the male connector to the AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input voltage (100-240V~ 50/60Hz\.

Caution: Please use the provided power cord.

03 Introduction