Trane DD1D120A9H51B, UD1D120A9H51B, UD1B060A9H31B, UD1C080A9H41B Lighting Instructions, To Shut OFF

Installer’s Guide

TABLE 12

GAS FLOW IN CUBIC FEET PER HOUR

2 CUBIC FOOT DIAL

SEC.	FLOW	SEC.	FLOW	SEC.	FLOW	SEC.	FLOW
8	900	29	248	50	144	82	88
9	800	30	240	51	141	84	86
10	720	31	232	52	138	86	84
11	655	32	225	53	136	88	82
12	600	33	218	54	133	90	80
13	555	34	212	55	131	92	78
14	514	35	206	56	129	94	76
15	480	36	200	57	126	96	75
16	450	37	195	58	124	98	73
17	424	38	189	59	122	100	72
18	400	39	185	60	120	104	69
19	379	40	180	62	116	108	67
20	360	41	176	64	112	112	64
21	343	42	172	66	109	116	62
22	327	43	167	68	106	120	60
23	313	44	164	70	103	124	58
24	300	45	160	72	100	128	56
25	288	46	157	74	97	132	54
26	277	47	153	76	95	136	53
27	267	48	150	78	92	140	51
28	257	49	147	80	90	144	50

g	Outlet Pressure Boss	Regulator
		Adjustment
Inlet Pressure
Boss (opt.)	On/Off Switch
	White-Rodgers 36G gas valve

h	On/Off Switch
	White-Rodgers 36F gas valve
22

					TABLE 13
Orifice				ALTITUDE ABOVE SEA LEVEL
Twist Drill
Size If		and Orifice Required At Other Elevations
Installed
At Sea
Level
	2000		3000		4000	5000	6000	7000	8000	9000	10000
42	42		43		43	43	44	44	45	46		47
43	44		44		44	45	45	46	47	47		48
44	45		45		45	46	47	47	48	48		50
45	46		47		47	47	48	48	49	49		50
46	47		47		47	48	48	49	49	50		51
47	48		48		49	49	49	50	50	51		52
54	54		55		55	55	55	55	56	56		56
55	55		55		55	56	56	56	56	56		57
56	56		56		57	57	57	58	59	59		60
57	58		59		59	60	60	61	62	63		63
58	59		60		60	61	62	62	63	63		64

From National Fuel Gas Code - Table F-4

LIGHTING INSTRUCTIONS

▲! WARNING

DO NOT attempt to manually light the burner.

Failure to follow this warning could result in property damage, personal injury or death.

Lighting instructions appear on each unit. Each installation must be checked out at the time of initial start up to insure proper operation of all components. Check out should include putting the unit through one complete cycle as outlined below.

Turn on the main electrical supply and set the thermo- stat above the indicated temperature. The ignitor will automatically heat, then the gas valve is energized to permit the flow of gas to the burners. After ignition and flame is established, the flame control module monitors the flame and supplies power to the gas valve until the thermostat is satisfied.

TO SHUT OFF

For complete shutdown: Move the control switch on the main gas valve to the “OFF” position (See Figures 25 and 26). Disconnect the electrical supply to the unit.

▲! CAUTION

If this is done during the cold weather months, provi- sions must be taken to prevent freeze-up of all water pipes and water receptacles.

Failure to follow this warning could result in property damage.

Whenever your house is to be vacant, arrange to have someone inspect your house for proper tem- perature. This is very important in below freez- ing weather. If for any reason your furnace should fail to operate damage could result, such as frozen water pipes.

18-CD21D1-5