| + | |
0 |
| |
I | + | |
| + | |
- | + | |
+ | ||
|
User’s Guide
CPSMP-130
48-VDC Power Supply Module
CPSMP-140
24-VDC Power Supply Module
13-Slot PointSystem™ Accessory
The Transition Networks
The Transition Networks
The figure below illustrates the components of both types of power supplies:
•An On/Off switch that, when set to “I”, allows the power supply module to supply power to the chassis, and any installed modules.
•A panel fastener screw that secures the power supply module to the chassis.
•A power LED indicator.
•A handle for installing and removing the power supply module to/from the chassis.
•A fuse installed on the circuit board inside the power supply module’s housing.
•A set of three (3) external power connectors that distribute power from an external DC outlet to a chassis ground connector, a positive (+) connector, and a negative
| On/Off Switch |
|
| |
I | Panel Fastener Screw | Install the Power Supply Module . | . . .3 | |
Power LED | ||||
0 | Connect to External Power | . . .4 | ||
|
| |||
| Handle | Replace the Power Supply Module | . . .6 | |
| Replace the Fuse | . . .8 | ||
- + |
| |||
Fuse | Technical Specifications | . .10 | ||
| (on the circuit board | Troubleshooting | . .11 | |
|
| Contact Us | . .11 | |
| External Power Connectors | Compliance Information | . .12 |