Transition Networks DVP 5960 technical specifications Media Converter Technical Specifications

Five years

MEDIA CONVERTER TECHNICAL SPECIFICATIONS

Host Connection	IBM® S/3x (System 34, 36, 38) host, AS/400™
	host or 5x94 remote controller
Case dimensions	4.75" x 3.0" x 1.0" (119mm x 76mm x 25mm)
Shipping Weight	2 pounds (0.9 kilograms)
Environment	Temperature:	0-50°C (32-122°F)
	Humidity	10-90%, non condensing
	Altitude	0-10,000 feet

Warranty

Power Supply Requirements Replace power supply with only the equivalent input rating (see below) and output rating (regulated 9VDC at 0.5 A).

TN PN	Requirement	Location
3525	240 volts, 50 hertz	United Kingdom
3525	230 volts, 50 hertz	Europe
3518	120 volts, 60 hertz	USA/Canada/Mexico
3514	100 volts, 50-60 hertz	Japan
3525	240 volts, 50 hertz	Australia

NOTE: This product also can be powered by the Transition Networks E-MCR series media converter rack.

Minneapolis, MN 55344 USA

5250 Copper/Fiber Media Converter

PS-CF-01, PS-CF-01(SC), PS-CF-01(SM)

USER’S GUIDE

The TRANSITION Networks 5250 Copper to Fiber PS-CF-01 series media converters, designed to support all IBM® 5250 compliant devices (including devices operating at a non-standard rates), extends the signal distance of an AS/400™ or S/3x host computer or a 5x94 remote controller to terminal equipment over twisted-pair copper and over multimode or singlemode fiber.

PS-CF-01 series media converters allow twisted-pair copper network extension distances up to 1524 meters (762 meters each connection on two media converters) AND fiber network extension distances up to 2 kilometers on multimode fiber and up to 8 kilometers on singlemode fiber.*

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

Compliance Information

UL Listed

PS-CF-01

Provides an RJ-45 twisted-pair connector to copper cable and a set of RX (receive) and TX (transmit) ST connectors to multimode fiber-optic cable.

PS-CF-01(SC)

PS-CF-01

PS-CF-01(SM)

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Provides an RJ-45 twisted-pair connector to copper cable and an RX (receive) and TX (transmit) SC connector to multimode fiber-optic cable.

Provides an RJ-45 twisted-pair connector to copper cable and an RX (receive) ST and TX (transmit) SC connector to singlemode fiber- optic cable.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Copyright Restrictions

© 1998 TRANSITION Networks.

All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners. 33060.A

STATUS LEDS

Power Steady green LED		Power
	TX RX
indicates connection
to external AC power.				10BASE-T
	Fiber		UTP/STP
UTP/STP Blinking green LED
indicates network traffic on unshielded or shielded twisted-pair
link.

Fiber Blinking green LED indicates network traffic on fiber link.

*See note at top of pages 4 & 5.