Transition Networks E-100BTX-SX-01 warranty Standards, Delay, Case dimensions, Shipping Weight

MEDIA CONVERTER TECHNICAL SPECIFICATIONS

Standards	100BASE-SX, IEEE 802.3u
Delay	400ns round trip
Case dimensions	4.7" x 3.0" x 1.0"		(119mm x 76mm x 25mm)
Shipping Weight	3 lbs	(0.9 kg)
Environment	Temperature:		0-40°C (32° to 100° F )
	Humidity		10-90%, non condensing
	Altitude		0-10,000 feet
Maximum number	2
media converters in series:

WarrantyLifetime

Power Supply Requirements Replace power supply with only the equivalent input rating (see below) and output rating (regulated 9VDC at 0.5 A).

TN PN	Requirement	Location
3525	240 volts, 50 hertz	United Kingdom
3525	230 volts, 50 hertz	Europe
3518	120 volts, 60 hertz	USA/Canada/Mexico
3514	100 volts, 50-60 hertz	Japan
3525	240 volts, 50 hertz	Australia

NOTE: This product also can be powered by the Transition Networks E-MCR series media converter rack.

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

Compliance Information

UL Listed

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates,

Minneapolis, MN 55344 USA

100BASE-TX/100BASE-SX Media Converters

850 Nanometer

E-100BTX-SX-01, E-100BTX-SX-01(SC)

USER’S GUIDE

The TRANSITION Networks Ethernet™ E-100BTX-SX-01 series 100BASE-TX to 100BASE-SX media converters connect 100BASE-TX unshielded twisted pair cable to 850 nm 100BASE-SX multimode fiber-optic cable, using either an ST connector (E-100BTX-SX-01) or an SC connector (E-100BTX-SX-01(SC)).

A four-positiion switch on the media converter allows selection of Auto- negotiation, half-duplex or full-duplex, and/or Link Pass Through (LPT) /Remote Fault Detection (RFD). An MDI/MDI-X switch allows straight- through twisted-pair cable to be used for crossover 100BASE-TX connections.

E-100BTX-SX-01	Config	X-MDI	MDI	UTP
	1 2 3 4
	Switches
Provides an RJ-45 twisted pair 100BASE-TX	9V DC Input		E-100BTX-SX-O4
connector and a set of RX (receive) and TX
(transmit) ST 100BASE-SX connectors to			S	850nm
850 nm multimode fiber-optic cable.				Multimode Fiber
		E-100BTX-SX-04
E-100BTX-SX-01(SC)	Config	X-MDI	MDI	UTP
	1 2 3 4
	Switches
Provides an RJ-45 twisted pair 100BASE-TX	9V DC Input		E-100BTX-SX-O4
connector and an RX (receive) and TX
(transmit) SC 100BASE-SX connector to			S	850nm
850 nm multimode fiber-optic cable.				Multimode Fiber
	E-100BTX-SX-04(SC)

Status LEDs on the connector side of the media converters indicate:

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

Power Illuminated green LED indicates connection to external AC power.

SDF Signal Detect/Fiber: Steady green LED indicates fiber port is connected to device.

SDC Signal Detect/Copper: Steady green LED indicates RJ-45 port is connected to device.

RJ-45 Connector

TX RX Power

SDF

SDC

	RXC
	RXF
Fiber			10BASE-T
		UTP/STP Power

SC Connectors

SDF

SDC

RXC

Copyright Restrictions

© 1998, 2001 TRANSITION Networks.

All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

RXC Receive/Copper: Flashing green LED indicates packets are seen on RJ-45 port.

RXF Receive/Fiber: Flashing green LED indicates packets are seen on fiber port.

RJ-45 Connector

TX RX Power

SDF

SDC

	RXC
Fiber	RXF	10BASE-T
		UTP/STP

ST Connectors

RXF

All registered trademarks and trademarks are the property of their respective owners. 33064.C