Transition Networks E-PSW-TX-02 Site Considerations, Installation, Part Number

2. SITE CONSIDERATIONS

The site for the Transition Networks’ pocket switch must provide:

•AC power outlet for each Transition Networks’ pocket switch

•Adequate ventilation

•Standard environmental conditions

•Isolation from electrical noise, including radio transmitters and broadband amplifiers, motors, high power electrical lines, or fluorescent light fixtures.

Additionally:

•The twisted pair cables should not run in the same conduit with power line cables.

•Phone lines should be separated from data cables.

•Flat or “silver satin” wires should not be used.

And:

•The entire installation should comply with the IEEE Ethernet 802.3 and the 802.3u specifications.

3. INSTALLATION

To install the Transition Networks’ pocket switch:

•Unpack Transition Networks’ pocket switch

•Install Transition Networks’ pocket switch on stable, flat surface

•Set DIP switch

•Install network cable

•Power Transition Networks’ pocket switch.

Direction is provided in the pages that follow.

Unpacking the Transition Networks’ Pocket Switch

The Transition Networks’ pocket switch packing contents should include the following:

Item	Part Number
Transition Networks’	E-PSW-TX-02
Pocket Switch	OR
	E-PSW-FX-02
Power Supply Adapter	3340, 3507, 3342, 3340, 3346, 3511,
	OR 3537/power cord: 3522 .
	(depending upon power configuration
	in country where installed)
User’s Guide	33015

Installing on Flat, Stable Surface

The Transition Networks’ pocket switch was designed and built to be installed on a table or shelf.

Ensure that the installation location is:

•stable

•well- ventilated

•near a standard AC electrical outlet.

13 Transition Networks’ Pocket Switch 14