Traulsen RBF134HUT-FHS, RBF234HUT-FHS, RFS126NUT owner manual Table Of Contents, I. The Serial Tag

TABLE OF CONTENTS

I. THE SERIAL TAG	Page 1	VII. FISH FILE MODELS
II. RECEIPT INSPECTION	Page 2	a-Fish File Application	Page 6
III. INSTALLATION		b-Special Installation Note	Page 6
a-Location	Page 2	c-Drawer Pans	Page 6
b-Packaging	Page 2	d-Product Loading	Page 6
c-Installing Legs or Casters	Page 2	e-Cleaning	Page 6
d-Shelf Pins	Page 2	VIII. BLAST FREEZER MODELS
e-Roll-In Model Installation	Page 3	a-Blast Freezer Application	Page 7
f-Installing The Condensate Evaporator	Page 3	b-Special Installation Note	Page 7
g-Remote Installation	Page 3	c-Interior Arrangements	Page 7
h-Cord & Plug	Page 3	d-Blast Freezing vs. Blast Chilling	Page 7
i-Power Supply	Page 4	e-Normal Operation	Page 7
j-Wiring Diagram	Page 4	f-Defrost	Page 7
k-Compressor Hold Down Provisions	Page 4	g-Blast Chill Operation	Page 7
l-Clearance	Page 4	h-Proper Packaging	Page 7
IV. CARE & MAINTENANCE		IX. STAINLESS STEEL OVERVIEW
a-Cleaning The Condenser	Page 4	a-Introduction	Page 8
b-Hinge Replacement	Page 4-5	b-Stainless Steel, How It Works	Page 8
c-Replacing The Gaskets	Page 5	c-Understanding The Causes of Corrosion	Page 8
d-Cleaning The Exterior	Page 5	X. CARE OF STAINLESS STEEL
e-Cleaning The Interior	Page 5	a-Using The Proper Tools	Page 8
V. MISC. OPERATIONS		b-Using The Right Cleanser	Page 8
a-Adjusting The Shelves	Page 5	c-Cleaning Do’s and Don’ts	Page 9
VI. OTHER		XI. CORROSION REMEDIES
a-Service Information	Page 5	a-Dealing With Rust After The Fact	Page 9
b-Spare Parts	Page 5	b-Dealing With Extreme Rust Situations	Page 9
c-Warranty Registration	Page 5	c-Restoring The Protective Layer	Page 9
		XII. TROUBLE SHOOTING GUIDE	Page 10
		XIII. WARRANTY INFORMATION	Back Cover

FORT WORTH, TX.

SERIAL	MODEL
VOLTS	Hz	PH
TOTAL CURRENT	AMPS
MINIMUM CIRCUIT	AMPS
MAXIMUM OVERCURRENT PROTECTION			AMPS
LIGHTS	WATTS
HEATERS	AMPS
REFRIGERANT		TYPE	OZ
DESIGN PRESSURE		HIGH	LOW
REFRIGERANT		TYPE	OZ
DESIGN PRESSURE		HIGH	LOW

370-60294-00 REV (A)

-1-

I. THE SERIAL TAG

The serial tag is a permanently affixed sticker on which is recorded vital electrical and refrigeration data about your Traulsen product, as well as the model and serial number. This tag is located in the upper right interior compartment on all reach-in/pass-thru and roll-in/roll-thru refrigerator, freezer and dual-temp models. For hot food and proofer models, this tag is located on the top of the unit behind the louvers to protect it from the heat.

READING THE SERIAL TAG

•Serial = The permanent ID# of your Traulsen

•Model = The model # of your Traulsen

•Volts = Voltage

•Hz = Cycle

•PH = Phase

•Total Current = Maximum amp draw

•Minimum Circuit = Minimum circuit ampacity

•Lights = Light wattage

•Heaters = Heater amperage (Hot Food units only)

•Refrigerant = Refrigerant type used

•Design Pressure = High & low side operating pressures and refrigerant charge

•Agency Labels = Designates agency listings