c. Bike 1 or 2 selecting & resetting the
When you are in
5.Setting clock time
Under any display mode except Stopwatch, press R button for 1 second. Clock time displayed. Repress either L or R button to return to “Odometer (ODO)” mode. Follow step 2 to complete setting clock time and 12/24 hour alternate.
a. 12/24 hours alternative.
When clock is displayed, press both L & R buttons at the same time. Clock will blink then press L or R button to switch between 12 hours and 24 hours. To reset clock, press L & R at the same time ( as following b.); after 3 seconds, clock will stop blinking automatically.
b. Resetting clock time
After choosing 12 or 24 hours, press L & R at the same time, minutes “MM” will blink (fig. 5). Advance them rapidly by holding the R button, or one at a time by pressing the R button (to go backward hold or press the L button). At the correct number press both L & R
buttons to confirm. Follow the same method to adjust hour “HH” to complete the whole setting. Press R button to move to other display modes after clock is set.
Installation
1.Use the attached rubber pad between the bracket and handlebar to provide a secure fit.
2.Slide the zip tie into bracket, position the bracket to the handlebar on either side or the stem.
3.Cut the excess zip tie off.
4. Slide the cyclometer into the bracket until it snaps up.
5.Remove the screw from the magnet and install it on one of the feasible spokes opposite the wheel sensor.
6.Install screw then tighten.
7.Mount the wheel sensor on the fork blade opposite the magnet using the zip tie provided.
8.Adjust the sensor until it is
Spoke
Channel Spoke
Screw
Test
Mount the computer in the bracket. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. If not, adjust positions of wheel magnet and fork sensor as described in installation steps
Page 4 | Page 5 |
