To select the wheel for use, Cycle Mode to TRP | Trek 11i, 9i

ODO	Set
TME
AVG
MAX
TRP

Mode

To select the wheel for use

1.Cycle Mode to TRP

2.Hold the left Mode and the right Mode together.

The Wheel Select icon changes (Figure 14). Repeat step 2 to change again.

Easy setup (ReSet)

15

Image 17

Trek 11i, 9i owner manual To select the wheel for use, Cycle Mode to TRP

Contents

Copyright Trek Bicycle Corporation 2006 All rights reserved Trek Incite 9i Contents Watch the road when riding Safety and general guidelines Function Explanation Functions CAD Mount InstallationStem mount Handlebar Speed sensor 31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebar Make sure the com- puter cannot be bounced off To install the computer on the stem Placing the magnet To install the wheel magnet To attach the computer wire Attaching the computer wire 0mm To install the sensorSensor can be rotated around the fork about 45 degrees Tighten the nylon ties and trim the excess length Figure Easy setup ReSet To set the units Using the buttonsSet Mode To set the odometer Temperature icon displayMH and KMH interchange on the screen Computer returns to the start screen Wheel Select icon appears on the screen To set wheel sizeWheel size appears Wheel size changes To select the wheel for use Cycle Mode to TRP 12 or 24 flashes To set Clock24 interchange on the screen Hour changes To ReStart set the Trip data to zero Max setting ReStarts at ‘0’ Using the computer in wet weather Changing modeAdditional information Removing the computer from the computer base Troubleshooting To replace the battery Replacing the battery Be careful to avoid losing the rubber O-ring seal ‘cross’ on the bat- tery points up Replacing the Battery To set the computer Setting custom wheel sizeSelecting the custom value 4-digit number Left-hand digit flashes Measuring rollout for wheel size To measure rollout for wheel size This warranty does not cover Limited WarrantyThis warranty covers