Trek 11i, 9i TROuBlEShOOTINg

9

TROuBlEShOOTINg

The Incite 9i computer is designed to be easy to install and

maintain. However, computers occasionally have problems.

Table 3 shows some possible problems, causes, and solutions:

Troubleshooting

Table 3- Common problems and solutions

Blank screen Computer is in shipping mode. Push a button.

Battery is dead, or installed incorrectly. reinstall good battery.

Erratic data Magnet misaligned or too far away. re-adjust magnet and sensor placement.

Battery power is low. replace battery.

no current speed Magnet misaligned or too far away. re-adjust magnet and sensor placement.

Speed is incorrect. Wheel size is incorrect. reset computer.

Sensor is not reading magnet properly. readjust magnet and sensor alignment.

Contents

Main MPH CLK TME AVG MAX TRP AVG TREK INCITE 9i and 11i CONTENTS SAfETy ANd gENERAl guIdElINES function Explanation fuNCTIONS Page INSTAllATION Placing the computer on the handlebar To install the computer on handlebar To install the computer on the stem Placing the magnet To install the wheel magnet Attaching the computer wire To attach the computer wire Attaching the sensors To install the sensor Page EASy SETuP (RESET) using the buttons To set the units To set the odometer To set wheel size To select the wheel for use To set Clock RESTART- gETTINg REAdy TO RIdE To ReStart (set the Trip data to zero) AddITIONAl INfORMATION Changing mode Removing the computer from the computer base using the computer in wet weather TROuBlEShOOTINg REPlACINg ThE BATTERy To replace the battery Page SETTINg CuSTOM WhEEl SIzE Selecting the custom value 4-digit number To set the computer Page To measure rollout for wheel size lIMITEd WARRANTy This warranty covers This warranty does not cover